X3の取扱説明書・マニュアル [全132ページ 3.62MB]
123804.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123804.pdf - 3.62MB
- キャッシュ
25908view
132page / 3.62MB
Replacing components100When maintaining the headlamps, please comply with the instructions in the separate Caring for your vehicle bro-chure.<Halogen low beams H7 bulb, 55 Watts Always wear gloves and eye protec-tion - the atmosphere within the bulb is pressurized. Failure to observe this pre-caution can lead to personal injury should the bulb be damaged. < Driver's side1.Apply the screwdriver from the on-board tool kit and pull off the lamp coverCaution when handling the screw-driver, as otherwise personal injury can occur or the vehicle can be damaged.< 2.Press the bulb holder downward and remove3.Remove the bulb, mount a new bulb4.Apply the bulb holder with the lower edge to the bracket and press it in until the lamp base locks in place.Front passenger sideBefore replacing the bulb, remove the res-ervoir for the windshield washing system from the bracket. To do so, loosen the bolt, refer to arrow, and place the reservoir to one side. Bear in mind that the windshield washing system reservoir is heavy. If you do not, injuries or damage to the vehi-cle can occur.< For bulb replacement procedure, refer to Driver's side.Halogen high beamsH7 bulb, 55 Watts Always wear gloves and eye protec-tion - the atmosphere within the bulb is pressurized. Failure to observe this pre-caution can lead to personal injury should the bulb be damaged. < Driver's side1.Open the clip and remove the lamp cover2.Press the bulb holder downward and remove, refer to Low beams3.Pull off the lamp base; fit a new lamp base
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54162 view
26389 view
21096 view
21244 view
23290 view
もっと見る