X3の取扱説明書・マニュアル [全132ページ 3.62MB]
	
	
	
	
	
		
			
				
				
					123804.pdf
					
					
					gizport  - 2013-09-06
					http://153.127.246.254/.../123804.pdf - 3.62MB 
 - キャッシュ
						29168view
					
					132page / 3.62MB
					
					
				 
				
			 
		 
	 
 
	 
 
	
	
	
		
		
	
	
	
	Driving40Selector lever positionsP R N D M/S + -Engine startedThe engine can only be started in selector-lever positions P - Park - or N - Neutral.Range selectionAn interlock prevents inadvertent gear-shifts into selector-lever positions R and P. To cancel the interlock, press the button on the front of the selector-lever knob.ShiftlockPress the brake pedal before shifting out of P or N; the shift command will not be executed unless the brake is applied - Shiftlock.<To prevent the vehicle from 'creeping' after you select a range, maintain pressure on the brake pedal until you are ready to start. If you leave the vehicle with the engine running, engage selector-lever position P and apply the handbrake. If you fail to do this, the vehicle could move.Never leave an unattended vehicle with the engine running, as such a vehicle rep-resents a potential safety hazard. <P ParkSelect only when the vehicle is stationary. The transmission locks to prevent the rear wheels from turning. R - ReverseSelect only when the vehicle is stationary. N - NeutralSelect only if your journey is interrupted for a longer period. D Drive - Automatic shift programThis position is designed for driving under all normal operating conditions. All forward gears are available. KickdownA kickdown provides you with maximum acceleration and the maximum road speed in position D. Press the accelerator pedal past the increased resistance point at the full-throttle position. M/S Manual mode and Sport ProgramShifting from D into M/S activates the Sport program and this is indicated with SD in the gear display. The Sport Program is designed for performance-oriented driving. The first time the selector lever is even slightly touched, the automatic transmis-sion shifts from the Sport program into manual operation. If you start to move the selector lever towards +, the transmission shifts upwards; moving it towards - shifts down-wards. The gear display shows M1 through M5. Upshifts and downshifts are executed only when they will result in a plausible combi-nation of engine and vehicle speed; thus, for example, a downshift that would cause the engine to overrev will not be executed by the system. The gear selected will 
 
	
		
			参考になったと評価
   5人が参考になったと評価しています。
5人が参考になったと評価しています。
		 
		
 
	
		
				その他の取扱説明書
				
					
		
								
									 
									61726 view
								 
		
								
									 
									30051 view
								 
		
								
									 
									24175 view
								 
		
								
									 
									24442 view
								 
		
								
									 
									26575 view
								 
		
		
		
				 
				
				
				
		もっと見る