X3の取扱説明書・マニュアル [全132ページ 3.62MB]
123804.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123804.pdf - 3.62MB
- キャッシュ
25908view
132page / 3.62MB
ReferenceAt a glanceControlsDriving tipsMobility 109on page 93. The symbol + is embossed on the cover.1.Open the cover of the BMW auxiliary terminal for jump-starting, refer to arrow 12.Connect one terminal clamp of the pos-itive/+ jumper cable to the positive ter-minal of the battery or a auxiliary termi-nal of the vehicle providing starting assistance3.Connect the second terminal clamp of the positive/+ jumper cable to the posi-tive terminal of the battery or to a auxil-iary terminal of the vehicle to be started. On your BMW, there is a special nut as body ground or negative terminal on the suspension strut dome, refer to arrow 24.Attach one end of the jumper cable minus/- to the negative terminal of the battery or to an engine or body ground of the vehicle providing assistance5.Connect the second terminal clamp of the negative/- jumper cable to the neg-ative terminal of the battery or to the engine or body ground of the vehicle to be started.Starting the engine1.Start the support vehicle's engine and let it run at an increased idling speed for a few minutes 2.Start the engine on the other vehicle in the usual way. If the first start attempt is not success-ful, wait a few minutes before another attempt in order to allow the discharged battery to recharge3.Allow the engines to run for several minutes4.Disconnect the jumper cables by reversing the connection sequence.If necessary, have the battery checked and recharged at a BMW Sports Activity Vehi-cle Center.Never use spray fluids to start the engine.< TowingAlways observe all applicable towing laws and regulations. Do not tow the BMW X3 with the axle raised, as otherwise the transfer case can be damaged. < Towing with a commercial tow truck>Use only a flatbed carrier>Do not tow with sling-type equipment>Do not use a wheel lift.Never allow passengers to ride on a towed vehicle for any reasons. <Tow fittingThe threaded tow fitting is stored in the tool kit mounted on the inside of the compart-ment and should always remain in the vehi-cle. This fitting is designed for installation in the tow sockets located at the front and rear of the vehicle.Access to tow sockets FrontUse a screwdriver to lever out the cover upward at the recess.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54162 view
26389 view
21096 view
21244 view
23290 view
もっと見る