X3の取扱説明書・マニュアル [全146ページ 4.87MB]
123811.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123811.pdf - 4.87MB
- キャッシュ
21854view
146page / 4.87MB
Adjustments32Requesting a stored settingDo not request a position from the mem-ory while the vehicle is moving; otherwise, there is a risk of accident from unexpected seat movement.<Convenience mode1.Open the driver's door after unlocking or turn the ignition key to position 1.2.Briefly press the desired memory button 1, 2 or3.The adjustment procedure is canceled when you press one of the seat adjustment buttons or use one of the memory buttons.Safety feature1.Close the driver's door and turn the ignition key to position 0 or 2.2.Press the desired memory button 1, 2 or3 and maintain pressure until the adjustment process has been completed.If the button has been pressed inadvert-ently:Press the button again, the LED goes out.You can have your vehicle programmed to automatically recall your own individual stored adjustment settings for the seat and exterior mirror position whenever you use your personal remote control to unlock the vehicle. <If you make use of this setting, be sure that the footwell behind the driver's seat is unobstructed before unlocking the vehicle. If you fail to do so, any persons, animals or objects behind the seat could be injured or damaged by a rearward movement of the seat.<Safety beltsTo ensure that the safety systems con-tinue to provide optimum protection, please follow the instructions on page 27.<Make sure the safety belt s are worn in all occu-pied seats every time you drive. Although air-bags enhance safety by providing added pro-tection, they are not a substitute for safety belts.FasteningMake sure you hear the latch plate engage in the belt buckle.Safety belt reminder for front seatsThe indicator lamp flashes or lights up. In addition, a signal sounds. Please make sure that the safety belts are being worn correctly.The safety belt reminder is activated if the safety belt on the driver's side has not yet been fastened. At speeds greater than 5 mph/8 km/h, the safety belt reminder is also activated if the pas-senger side safety belt has not yet been fas-tened, if objects are placed on the passenger's seat, or if the driver or front passenger's safety belt is released.Releasing1.Hold the belt firmly.2.Press the red button in the buckle.3.Guide the belt back into its reel.The upper shoulder stra p's anchorage point will be in the correct position for seat occupants of every build if the seat is correctly adjusted, refer to page27.In the rear, the middle belt buckle embossed with the word CENTER is intended exclusively for use by passengers riding in the center posi-tion.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
53119 view
26085 view
20837 view
20989 view
23008 view
もっと見る