Z4の取扱説明書・マニュアル [全120ページ 3.44MB]
123816.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123816.pdf - 3.44MB
- キャッシュ
28338view
120page / 3.44MB
Opening and closing26Arming and disarming the alarm systemWhen the vehicle is locked or unlocked either via the driver's door lock or with the remote control, the alarm system is simul-taneously armed or disarmed.The hazard warning flashers blink once when the alarm system has been properly armed.You can have different acknowledg-ment signals set to confirm arming and disarming.<You can still open the luggage compart-ment lid when the system is armed by pressing the remote control button, refer to page 17. When it is closed, the lid is once again secured.Manual operation of the luggage compartment lid triggers the alarm. Refer to page 19.<To cancel an alarm: Press the button on the remote control, refer to page 16, or turn the ignition key to position 1. Refer to page 36.Indicator lamp displays>The indicator lamp beneath the interior mirror flashes continuously:The system is armed>The indicator lamp flashes when it is being armed: A door, the hood or luggage compart-ment lid is not completely closed. Even if you do not close the area causing the alert, the remaining areas are secured and the indicator lamp flashes continu-ously after 10 seconds. However, the interior motion sensor is not activated>If the indicator lamp goes out as soon as the system is disarmed: No manipulation or attempted intru-sions have been detected in the period since the system was armed>If the indicator lamp flashes for 10 seconds when the system is being disarmed: An attempted entry has been detected in the period since the system was armed.After an alarm has been triggered, the indi-cator lamp will flash continuously.Interior motion sensor * The system monitors the footwells and the seating areas of the driver and passenger.Deactivate the interior motion sensor, refer to Avoiding unintentional alarms, if children or animals are to remain in the vehicle.<Avoiding unintentional alarms The tilt alarm sensor and interior motion sensor can be deactivated at the same time. You can do this to prevent a false alarm from being triggered, for instance in garages with elevator ramps or when the vehicle is transported by train.Lock the vehicle twice = arm the system:Press the button on the remote control twice in succession,orlock the vehicle twice with the key. Refer to page 18.The indicator lamp lights up briefly and then flashes continuously. The tilt alarm sensor and the interior motion sensor are deactivated as long as the system is armed.
参考になったと評価
18人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る