Z4の取扱説明書・マニュアル [全120ページ 3.44MB]
123816.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123816.pdf - 3.44MB
- キャッシュ
28338view
120page / 3.44MB
Driving445Rotary dial for control of the wipe inter-val or the sensitivity of the rain sensorIntermittent operationNot on vehicles with rain sensor.You can set the wipe interval over four stages with rotary dial 5.In addition, the wipe interval is varied auto-matically depending on road speed.Rain sensor The rain sensor is positioned on the wind-shield, directly behind the interior rearview mirror. To activate the rain sensor:>With the ignition key in position 1 or higher, move the lever to position 1. The wipers travel once across the wind-shield, regardless of the weather.You can leave the lever permanently in position 1, it is then only necessary to acti-vate the rain sensor. To do this>turn rotary dial 5 briefly.To adjust the sensitivity of the rain sensor: turn rotary dial 5.To deactivate the rain sensor:return lever to position 0.Turn the rain sensor off in automatic car washes. Failure to do so could result in damage caused by undesired wiper activation.<Normal wiper speedWhen the vehicle is stationary, the wipers automatically switch to intermittent wipe, not on vehicles with rain sensor.Fast wiper speedWhen the vehicle is stationary, the wipers operate at normal speed, not on vehicles with rain sensor.Cleaning windshield and headlamps* 0Wipers retracted1Cleaning windshield and headlamps*Do not use the washers if there is any danger that the fluid will freeze on the windshield, otherwise vision could be obscured. For this reason, use an anti-freeze agent. Refer to page 83.Do not use the washers when the reservoir is empty. Otherwise damage to the washer pump could result. <Cleaning the windshield The system sprays washer fluid against the windshield and activates the wipers for a brief period.Cleaning the headlamps When the vehicle's lighting system is switched on, the headlamps are cleaned at reasonable intervals.Windshield washer nozzlesThe windshield washer nozzles are heated automatically* in ignition position 2.
参考になったと評価
18人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る