Z4の取扱説明書・マニュアル [全120ページ 3.44MB]
123816.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123816.pdf - 3.44MB
- キャッシュ
28338view
120page / 3.44MB
ReferenceAt a glanceControlsDriving tipsMobility 37the ignition key immediately when the engine starts.<Extended starting attempts, charac-terized by excessively frequent or long periods with the starter engaged, can damage the catalytic converter. <If the engine fails to start on the first attempt, for instance if it is very hot or cold: >Press the accelerator pedal halfway down.Cold starts at very low temperatures, start-ing at approx. 57/-156:>Press the accelerator pedal halfway down.>On the first start attempt, engage the starter for a longer period, approx. 10 seconds.Manual transmission1.Engage the parking brake2.Gearshift lever in idling position3.Depress clutch pedal4.Start the engine.Automatic transmission1.Depress footbrake2.Place selector lever in position P or N3.Start the engine.Before leaving the vehicle with the engine running, place the selector lever in position P and pull the parking brake.Do not leave the vehicle unattended with the engine running. An unattended vehicle with a running engine poses a safety haz-ard.<Sequential manual gearbox SMG1.Depress footbrake2.Move selector lever to neutral position N3.Start the engine.If the engine does not start, re-engage the gear last selected, refer to the display in the instrument cluster, and move the selector lever to neutral position N again.<Before leaving the vehicle with the engine running, place the selector lever in position N and pull the parking brake.Do not leave the vehicle unattended with the engine running. An unattended vehicle with a running engine poses a safety haz-ard.<Switching off the engineDo not remove the ignition key while the vehicle is still moving. If you did so, the steering lock would engage when the steering wheel is turned. When you leave the vehicle, always remove the ignition key and engage the steering lock.Always engage the parking brake when parking on downhill roads. <You can have an acoustic signal set as a reminder that the ignition key is still in the ignition switch after the driver's door has been opened. <Manual transmissionTurn the ignition key to position 1 or 0.Automatic transmissionPlace the selector lever in position P and turn the ignition key to position 1 or 0.Sequential manual gearbox SMGIf you turn the ignition key to position 1 or 0 with the selector lever in position R, or in sequential mode, a gear automatically remains engaged.If you turn the ignition key to position 1 or 0 with the selector lever in neutral position N, a warning tone and the flashing gear indi-cator in the display remind you that the vehicle is not secured against rolling.The warning stops after approx. 9 seconds.Always engage the parking brake when parking on downhill roads. Engaging a gear may not sufficiently secure the vehicle against rolling. <
参考になったと評価
18人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る