G5WPの取扱説明書・マニュアル [全87ページ 5.18MB]
	 
	
	
	
	
		
			
				
				
					G5WP_UM_Eng.pdf
					
					
					gizport  - 2013-09-02
					http://www.general-imaging.com/.../G5WP_UM_Eng.pdf - 5.18MB 
 - キャッシュ
						23331view
					
					87page / 5.18MB
					
					
				 
				
			 
		 
	 
 
	 
 
	
	
	
		
		
	
	
	
	66 67If the USB option is set to [PC]  :Turn the camera of and disconnect the USB cable.If the USB option is set to [PC (PTP) ] :Remove the camera from the system as described below before turning the camera of and disconnecting the USB cable.By using the USB cable, you can transfer the captured photos and videos to a PC. Follow the steps below to connect the camera to a PC.1. Start a computer to which ArcSoft software has been installed.2. Make sure both the camera and PC are turned on. 3. Connect one end of the supplied USB cable to the USB/AV OUT port on your camera.4. Connect the other end of the cable to an available USB port on your PC.5. Disconnect the camera once transfer is completed.
 
	
		
			参考になったと評価
   3人が参考になったと評価しています。
3人が参考になったと評価しています。