MENTOR MENUETの取扱説明書・マニュアル [全34ページ 2.24MB]
2
103.6 Ribbon Tweeter Rotation on MENTOR LCROn MENtOR LcR the ribbon tweeter can be rotated 90 degrees if the speaker is used as a center channel in very wide set-ups. the ribbon tweeters are pre-conigured for vertical positioning in the factory. If the speaker is used as center channel in wide set-ups, your authorized dealer or service facility can rotate the ribbon tweeter for you.Remove the ribbon tweeter from the cabinet using a 3 mm Allen key to remove the four screws. When disassembled, rotate the ribbon tweeter 90 degrees. Insert the rotated ribbon tweeter and install it, using the four screws. Be careful not to over tighten the screws when assembling the speaker again (see igure 8).3.7 Grille position on MENTOR LCRthe grilles of the speakers are factory itted for vertical positioning, i.e. the upper edge of the grille is lush with the upper edge of the grey bafle. If the speaker is used in the horizontal position, the grille can be rotated 180 degrees. the grille will thereby be symmetrical round the center axis of the speaker (see igure 9).3.8 Logo placement on MENTOR LCRthe speaker is delivered with a separate DALI logo badge, since the logo badge placement depends on the chosen placement for the speaker (vertically or horizontally) (see igure 9). If the speaker is mounted in a vertical position, the logo badge should be positioned on the grey front bafle. If the speaker is in the horizontal direction, the logo should be positioned on the grille. Please see and use the enclosed positioning template for mounting the logo badge. If you are in doubt about how to mount the logo badge, please consult your DALI dealer.4.0 CONNECTIONcorrect, tight connections to your ampliier are extremely important for your listening experience. Always use cables of the same type and length for left and right channels. We recommend using special speaker cables from DALI, available from your dealer.connection in correct phase is a detail that is often ignored. the red (+) terminal of the ampliier must be connected to the red (+) terminal of the loudspeaker. the black (-) terminal of the ampliier must be connected to the black (-) terminal of the loudspeaker. (see igure 10).For the optimal listening experience, the right loudspeaker (as seen from the listening position) must be connected to the ampliier output terminals marked “R” or “Right” the left loudspeaker must be connected to the ampliier output terminals marked “L” or “Left” Even a single loudspeaker connected out-of-phase in a stereo or surround installation will make the bass weaker and the stereo image unfocused.Note: Before connecting cables or changing any connections, ALWAYS turn off your ampliier.Note:Make sure that the bare conductors are tightly gripped by the terminals with no loose wires that could cause a short circuit and damage the ampliier.Note:If you are using MENtOR in a surround system, follow the instructions included with your surround ampliier.
