ZENSOR1 の使い方、故障・トラブル対処法

4 3FIGURE 3C FIGURE 3D FIGURE 3EFIGURE 2 FIGURE 3A FIGURE 3BZENSOR 1ZENSOR 5ZENSOR 7ZENSOR VOKALFrequency Range [+/- 3] dB [Hz] 53 - 26.50043 - 26.50040 - 26.50047 - 26.500Sensitivity [2.83V/1m] [dB] 86,588,090,088,5Nominal Impedance [ohms] 6666Maximum SPL [dB] 106108110109Recommended Amp. Power [Watts]25 - 10030 - 15030 - 15030 - 120Crossover Frequencies [Hz] 2.9002.4002.4002.400Crossover Principle 2-way2-way2-way2-wayHigh Frequency Driver 25 mm soft dome25 mm soft dome25 mm soft dome25 mm soft domeLow Fre...

UKDEDK5JPCONTENTS / INHALT / INDHOLD / 内容ENGLISH 6DEutScH 12DANSK 18日本 24

6CAUTIONRISK OF ELEctRIc SHOcK DO NOt OPEN.tO REDucE tHE RISK OF ELEctRIc SHOcK,DO NOt REMOVE tHE BAcK PANEL.NO uSER-SERVIcEABLE PAR tS INSIDE.REFER SERVIcING tO QuALIFIED PERSONNEL.the lightning lash within an equilateral triangle isintended to alert you to the presence of non insulated“dangerous voltage” within the product’s enclosure thatmay be of suficient magnitude to constitute an electricshock to persons.the exclamation point within an equilateral triangleis intended to alert you to the presence of i...

UKDEDK7JPCONTENTS1.0 INtRODuctION 82.0 uNPAcKING 83.0 POSItIONING 84.0 cONNEctION 95.0 RuNNING-IN 106.0 cLEANING AND MAINtENANcE 107.0 DISPOSAL 108.0 POWER AND AcOuStIc PRESSuRE 109.0 tHE LIStENING ROOM 1110.0 tEcHNIcAL SPEcIFIcAtIONS 11

81.0 INTRODUCTIONcongratulations with your new DALI ZENSOR loudspeaker. It is important to us that your new DALI loudspeakers are set up and connected optimally. For this reason, we recommend that you read this manual and follow its recommendations. the manual contains instructions for setup and connection, as well as tips and advice on how to get the most out of your new loudspeakers. DALI is acclaimed around the world for unique loudspeakers built to our uncompromising standards for design and performanc...

UKDEDK9JP3.1 DALI ZENSOR 1the speaker can be positioned on a stand/shelf or hung on a wall using the integrated wall bracket. If positioned on a stand or shelf, the enclosed rubber bumpers can be mounted under the speaker for stable and vibration free positioning, see Figure 3A. If hung on a wall, mount thebumpers on the rear edges of the speakers, see Figure 3B. the speakers are hung on a wall using one screw mounted in the wall. the screw must it the wall bracket on the rear side of the speaker, see Fig...

UKDEDK11JPIt is worth noting that turning tone controls above the neutral setting signiicantly burdens both speakers and ampliier. On a good sound system, tone controls should only be used to compensate for poor recordings and not to permanently compensate for weaknesses elsewhere in the system. DALI recommends the tone controls generally be set to the neutral position, and to achieve your desired sound image through correct positioning of the speakers. Ensuring that you keep the volume low enough for the s...

105.0 RUNNING-INLike any mechanical system, a loudspeaker requires a “running-in” period to perform at its best. You will experience a gradual increase in sound quality during the irst period of use. the break-in period will vary depending on use and playback volume. You should expect up to 100 hours of playback until maximum performance is reached. unlike other mechanical systems, the life-span of a loudspeaker is increased by normal, regular playback of music.6.0 CLEANING AND MAINTENANCEclean the cabinet...

12VORSICHTELEKtROScHOcKGEFAHR – NIcHt ÖFFNEN.ZuR REDuZIERuNG DER ELEKtROScHOcKGEFAHRDIE RÜcKWAND NIcHt ABNEHMEN. DAS GERÄtENtHÄLt KEINE VOM BENutZER WAR tBAREN tEILE.WARtuNGSARBEItEN NuR VON QuALIFIZIER tEMPERSONAL AuSFÜHREN LASSEN.Das Blitzsymbol in einem gleichseitigen Dreieck sollSie darauf aufmerksam machen, dass innerhalbdes Gerätes unisolierte „gefährliche Spannungen“vorliegen, deren Größenordnung ausreichen kann, umeinen elektrischen Schlag zu verursachen.Das Ausrufezeichen in einem gleichseitigen Dr...