S P E C F I L EPT-LB1VLCD ProjectorAs of May 2011SFL11M0018/10Control commands*1Do not send PON, POF, or OSH commands continuously in a short period of time (0.5 second or less). Doing so may burst the lamp or shorten the lamp replacement cycle.*2These commands are effective when the standby mode is set to eco. (Other commands are not effective.)PON *1/*2POF *1/*2AVL:<pl>IIS:<input signal>OSTOFZ:<off on>OENOXG:0OXG:1OXG:2VPM:<NAT>VPM:<STD>VPM:<DYN>VPM:<BBD>VPM:<WBD>VXX:DLVI0=<+00000>VXX:DLVI0=<+00001>VXX:DLVI0=<+00002>AUUAUDOMNOCUOCDOCLOCROASOSH*1OIXDZUDZDPower on (standby mode on)Power off (standby mode off)Volume controlInput signal selectionThe same function as "default" buttonFreezeEnterWide mode: OffWide mode: OnWide mode: AutoPicture mode: NaturalPicture mode: StandardPicture mode: DynamicPicture mode: BlackboardPicture mode: WhiteboardDaylight View: OffDaylight View: AutoDaylight View: OnVolume upVolume downMenuCursor upCursor downCursor leftCursor rightAuto setupAV muteIndex windowDigital zoom: EnlargementDigital zoom: ReductionPONPOFAVL:<pl>IIS:<input signal>OSTOFZ:<off on>OENOXG:0OXG:1OXG:2VPM:<NAT>VPM:<STD>VPM:<DYN>VPM:<BBD>VPM:<WBD>VXX:DLVI0=<+00000>VXX:DLVI0=<+00001>VXX:DLVI0=<+00002>AUUAUDOMNOCUOCDOCLOCROASOSHOIXDZUDZD--0--0--------------------------63--1------------------------Command: <Parameter> Function Callback: <Parameter> Parameter valueMin Max
