LS-30の取扱説明書・マニュアル [全49ページ 3.39MB]
ls30rm.pdf
gizport - 2013-09-08
http://www.nikonusa.com/.../ls30rm.pdf - 3.39MB
- キャッシュ
18582view
49page / 3.39MB
- 23 -Setup: Connecting the SCSI CableSCSI devices cannot be connected while the power is on.Before connecting the scanner to the SCSI chain, be sure thatthe computer and all other devices in the chain, including thescanner, are off. How the scanner should be connected to thechain depends on whether it is to be located between otherdevices or attached at the end of the chain.When the scanner is the last device in the chainSet the terminator switch on the rear of the scanner to ON.TERMINATOROFF ONConnect the SCSI cable to either of the two SCSI connectorson the rear of the scanner.MADE IN JAPAN100098SCSI SCSISCSI NBTERMINATOROFF ON65432107Connect the other end of the cable to the next device in thechain. If the scanner is the only external device in the chain,connect the cable to the computer's SCSI port.MADE IN JAPAN 100098SCSI SCSISCSI NBTERMINATOROFF ON65432107100-240V~0.3-0.2A50/60 HzIf there are other external devices in the chain, connect thescanner to the last of these devices.Other SCSI device Other SCSI deviceMADE IN JAPAN 100098SCSI SCSISCSI NBTERMINATOROFF ON65432107100-240V~0.3-0.2A50/60 Hz4 Caution: Do not touch theconnector pins with your fingers or withmetal objects, as this could result instatic electricity damaging one or moreof the devices in the SCSI chain.
参考になったと評価
4人が参考になったと評価しています。
この取扱説明書が関連付けられている製品