Aspire 5741の取扱説明書・マニュアル [全2345ページ 37.05MB]
52EnglishTBR 21This equipment has been approved [Council Decision 98/482/EC - "TBR 21"] for single terminal connection to the Public Switched Telephone Network (PSTN). However, due to differences between the individual PSTNs provided in different countries, the approval does not, of itself, give an unconditional assurance of successful operation on every PSTN terminat ion point. In the event of problems, you should contact your equipment supp lier in the first instance. For more information about applicable countries, please refer to "Regulations and safety notices" on page 50Notice for AustraliaFor safety reasons, only connect headsets with a telecommunications compliance label. This includes customer equipment previously labelled permitted or certified.Notice for New Zealand1 The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its netw ork. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services.2 This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for which it is designed. Telecom will accept no responsibility should difficulties arise in such circumstances.3 Some parameters required for comp liance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this device. The associated equipment shall be set to operate within the following limits for compliance with Telecom's Specifications:a There shall be no more than 10 call attempts to the same number within any 30 minute period for any single manual call initiation, andb The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next call attempt.4 Some parameters required for comp liance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this device. In order to operate within th e limits for compliance with Telecom's specifications, the associated equipment shall be set to ensure that automatic calls to different numbers ar e spaced such that there is not less than 5 seconds between the end of one call attempt and the beginning of another.