ISの取扱説明書・マニュアル [全26ページ 1.07MB]
3
24 / 26 ページ
現在のページURL
1392-1. Driving procedures2When drivingTurn signal levernTurn signals can be operated whenThe "ENGINE START STOP" switch is in IGNITION ON mode.nIf the indicators flash faster than usualCheck that a light bulb in the turn signal lights has not burned out.Right turnLeft turnMove and hold the lever part-way to signal a lane changeThe right hand signal will flashuntil you release the lever.Move and hold the lever part-way to signal a lane changeThe left hand signal will flashuntil you release the lever.
参考になったと評価 
3人が参考になったと評価しています。
このマニュアルの目次
-
1 .1162-1. Driving procedure...1162-1. Driving proceduresDriving the vehicleThe following procedures should be observed to ensure safe driving. nStarting the engine (→P. 126)nDrivingAutomatic transmissionWith the brake pedal depressed, shift the shift lever to D. (→P. 131)Release the pa...
-
2 .1172-1. Driving procedure...1172-1. Driving procedures2When drivingStarting on a steep uphillAutomatic transmissionFirmly set the parking brake and shift the shift lever to D. Gently depress the accelerator pedal. Release the parking brake. Manual transmissionWith the parking brake f...
-
3 .1182-1. Driving procedure...1182-1. Driving proceduresnStarting off on a hill (vehicles with an automatic transmission)Hill-start assist control will operate. ( →P. 186)nDriving in the rainlDrive carefully when it is raining, because visibility will be reduced, the windowsmay become ...
-
4 .1192-1. Driving procedure...1192-1. Driving procedures2When drivingCAUTIONnWhen starting the vehicleWith automatic transmission vehicles, always keep your foot on the brake pedalwhile stopped with the engine running. This prevents the vehicle from creeping.nWhen driving the vehiclelD...
-
5 .1202-1. Driving procedure...1202-1. Driving proceduresCAUTIONlDo not turn the engine off while driving. The power steering and brake booster system will not operate properly if theengine is not running.lUse engine braking (downshift) to maintain a safe speed when driving down asteep ...
-
6 .1212-1. Driving procedure...1212-1. Driving procedures2When drivingCAUTIONnWhen driving on slippery road surfaceslSudden braking, acceleration and steering may cause tire slippage and reduceyour ability to control the vehi cle, resulting in an accident.lSudden changes in engine speed...
-
7 .1222-1. Driving procedure...1222-1. Driving proceduresCAUTIONnWhen the vehicle is parkedlDo not leave glasses, cigarett e lighters, spray cans, or soft drink cans in the vehi-cle when it is in the sun.Doing so may result in the following.* Gas may leak from a cigarette lighter or sp...
-
8 .1232-1. Driving procedure...1232-1. Driving procedures2When drivingCAUTIONnWhen taking a nap in the vehicleAlways turn the engine off. Otherwise, you may accidentally move the shift lever ordepress the accelerator pedal, which could cause an accident or fire due to engineoverheating....
-
9 .1242-1. Driving procedure...1242-1. Driving proceduresNOTICEnWhen driving the vehicleWith automatic transmission vehicleslDo not use the accelerator pedal or depress accelerator and brake pedalstogether to hold the vehicle on a hill.With manual transmission vehicleslDo not rest your ...
-
10 .1252-1. Driving procedure...1252-1. Driving procedures2When drivingNOTICEnIf you hear a squealing or scraping no ise (brake pad wear limit indicators)Have your Lexus dealer check and replac e the brake pads as soon as possible.The rotor damage can result if the pads are not replaced ...
-
11 .1262-1. Driving procedure...1262-1. Driving proceduresEngine (ignition) switchPerforming the following operations when carrying the electronic key onyour person starts the engine or changes "ENGINE START STOP" switchmodes.nStarting the engineAutomatic transmissionCheck that the parki...
-
12 .1272-1. Driving procedure...1272-1. Driving procedures2When drivingManual transmissionCheck that the parking brake is set.Check that the shift lever is set in N.Firmly depress the clutch pedal.The "ENGINE START STOP" switch indicator turns green.Press the "ENGINE STARTSTOP" switch.Th...
-
13 .1282-1. Driving procedure...1282-1. Driving proceduresnChanging "ENGINE START STOP" switch modeModes can be changed by pressing the "ENGINE START STOP"switch with the brake pedal (vehic les with an automatic transmission)or clutch pedal (vehicles with a manual transmission) released...
-
14 .1292-1. Driving procedure...1292-1. Driving procedures2When drivingnIf the engine does not startThe engine immobilizer system may not have been deactivated. ( →P. 77)nWhen the steering lock cannot be releasednWhen the "ENGINE START STOP" switch indicator flashes in amberThe system ma...
-
15 .1302-1. Driving procedure...1302-1. Driving proceduresCAUTIONnWhen starting the engineAlways start the engine while sitting in the driver's seat. Do not press the accelera-tor while starting the engine under any circumstances.Doing so may cause an accident resu lting in death or seri...
-
16 .1312-1. Driving procedure...1312-1. Driving procedures2When drivingAutomatic transmission∗Select a shift position appropriate for the driving conditions.nShifting the shift leverWhile the "ENGINE START STOP" switch is in IGNITIONON mode, depress the brake pedal and move the shift lev...
-
17 .1322-1. Driving procedure...1322-1. Driving proceduresSelecting shift ranges in the D positionTo drive using temporary shift range se lection, operate the "-" shift paddleswitch. The shift range can then be selected by operating the "-" and "+"shift paddle switches. Changing the sh i...
-
18 .1332-1. Driving procedure...1332-1. Driving procedures2When drivingnShift ranges and their functionsA lower shift range will provide greater engine braking forces than a higher shiftrange.Shift range Function6Automatically selecting gears between 1 and 6 according to vehicle speed an...
-
19 .1342-1. Driving procedure...1342-1. Driving proceduresChanging shift ranges in S modeTo enter S mode, shift the shift lever to the S position. The shift range canthen be selected by operating the "-" and "+" shift paddle switches or theshift lever. Changing the shift range a llows r...
-
20 .1352-1. Driving procedure...1352-1. Driving procedures2When drivingnWhen the "-" shift paddle switch is operated in the D positionWhen the "-" shift paddle switch is operat ed in the D position, a shift range will beautomatically selected. The highest gear of the first shift range wi...
-
21 .1362-1. Driving procedure...1362-1. Driving proceduresnIf does not come on even after shifting the shift lever to SThis may indicate a malfunction in the automatic transmission system. Have thevehicle inspected by your Lexus dealer immediately. (In this situation, the vehicle will op...
-
22 .1372-1. Driving procedure...1372-1. Driving procedures2When drivingManual transmission∗nShifting the shift leverFully depress the clutch pedalbefore operating the shift lever,and then release it slowly.nShifting the shift lever into RShift the shift lever into the Rposition while lif...
-
23 .1382-1. Driving procedure...1382-1. Driving proceduresSnow modeThe snow mode is used for accel-erating and driving on slipperyroad surfaces, such as on snow. Push the switch once more toreturn to normal mode. nMaximum downshifting speedAdhere to the downshifting speeds in the followi...
-
24 .1392-1. Driving procedure...1392-1. Driving procedures2When drivingTurn signal levernTurn signals can be operated whenThe "ENGINE START STOP" switch is in IGNITION ON mode.nIf the indicators flash faster than usualCheck that a light bulb in the turn signal lights has not burned out....
-
25 .1402-1. Driving procedure...1402-1. Driving proceduresParking brakeNOTICEnBefore drivingFully release the parking brake.Driving the vehicle with the parking brake set will lead to brake components over-heating, which may affect braking performance and increase brake wear.Vehicles wi...
-
26 .1412-1. Driving procedure...1412-1. Driving procedures2When drivingHornnAfter adjusting the steering wheel (vehicle s with manually adjustable type steer-ing wheel)Make sure that the steering wheel is securely locked.The horn may not sound if the steeri ng wheel is not securely locke...
