ISの取扱説明書・マニュアル [全23ページ 0.79MB]

1 .

1082-1. Driving proceduresDriving the vehicleThe following procedures should be observed to ensure safe driving. nStarting the engine (→P. 117)nDrivingAutomatic transmissionWith the brake pedal depressed, shift the shift lever to D. (→P. 122)Release the pa...

2 .

1092-1. Driving procedures2When drivingStarting on a steep uphillAutomatic transmissionFirmly set the parking brake and shift the shift lever to D. Gently depress the accelerator pedal. Release the parking brake. Manual transmissionWith the parking brake f...

3 .

1102-1. Driving proceduresnDriving in the rainlDrive carefully when it is raining, because visibility will be reduced, the windowsmay become fogged-up, and the road will be slippery.lDrive carefully when it starts to rain, because the road surface will be ...

4 .

1112-1. Driving procedures2When drivingCAUTIONnWhen starting the vehicleWith automatic transmission vehicles, always keep your foot on the brake pedalwhile stopped with the engine running. This prevents the vehicle from creeping.nWhen driving the vehiclelD...

5 .

1122-1. Driving proceduresCAUTIONlDo not turn the engine off while driving. The power steering and brake booster system will not operate properly if theengine is not running.lUse engine braking (downshift) to maintain a safe speed when driving down asteep ...

6 .

1132-1. Driving procedures2When drivingCAUTIONnWhen shifting the shift leverWith automatic transmission vehicles, be ca reful not to shift the shift lever with theaccelerator pedal depressed.This may lead to unexpected rapid acceleration of the vehicle tha...

7 .

1142-1. Driving proceduresCAUTIONlDo not leave the engine running in an area with snow build-up, or where it issnowing. If snowbanks build up around the vehicle while the engine is running,exhaust gases may collect and enter the vehi cle. This may lead to...

8 .

1152-1. Driving procedures2When drivingCAUTIONlThe brake system consists of 2 individual hydraulic systems: if one of the systemsfails, the other will still operate. In this case, the brake pedal should be depressedmore firmly than usual and braking dista...

9 .

1162-1. Driving proceduresNOTICEnIf you hear a squealing or scraping no ise (brake pad wear limit indicators)Have your Lexus dealer check and replac e the brake pads as soon as possible.The rotor damage can result if the pads are not replaced when needed. ...

10 .

1172-1. Driving procedures2When drivingEngine (ignition) switchModes can be switched by pressing the "ENGINE START STOP" switchwhen carrying the electronic key on your person. (The engine can bestarted in any mode by operating the switch at the same time a...

11 .

1182-1. Driving proceduresManual transmissionCheck that the parking brake is set.Check that the shift lever is set in N.Firmly depress the clutch pedal.The "ENGINE START STOP" switch indicator turns green.Press the "ENGINE STARTSTOP" switch.STEP 1STEP 2STE...

12 .

1192-1. Driving procedures2When drivingnChanging "ENGINE START STOP" switch modeOFF*Emergency flashers can beused.ACCESSORY modeSome electrical componentssuch as the audio system can beused. The "ENGINE START STOP"switch indicator turns amber.IGNITION ON m...

13 .

1202-1. Driving proceduresnIf the engine does not startThe engine immobilizer system may not have been deactivated. ( →P. 72)nWhen the "ENGINE START STOP" switch indicator flashes in amberThe system may be malfunctioning. Have the vehicle inspected by your...

14 .

1212-1. Driving procedures2When drivingNOTICEnTo prevent battery dischargeDo not leave the "ENGINE START STOP" switch in ACCESSORY or IGNITIONON mode for long periods without the engine running.nWhen starting the engine lDo not race a cold engine.lIf the e...

15 .

1222-1. Driving proceduresAutomatic Transmission (if equipped)Select a shift position appropriate for the driving conditions.nShifting the shift leverWhile the "ENGINESTART STOP" switch isin IGNITION ONmode, depress the brakepedal and move the shiftlever.

16 .

1232-1. Driving procedures2When drivingnShift position uses*1: To improve fuel consumption and reduce noises, set the shift lever in the Dposition for normal driving.*2:Selecting shift ranges using S mode re stricts the upper limit of the possiblegear rang...

17 .

1242-1. Driving proceduresChanging shift ranges in S modeShift the shift lever to the S position and operate the shift lever or shiftpaddle switch. UpshiftingDownshiftingThe initial shift range in S mode is auto matically set to 5 or 4 according tovehicle ...

18 .

1252-1. Driving procedures2When drivingnGear position display when driving in S modeThe current gear is displayed on the multi-information display. ( →P. 142)nDownshifting restrictions wa rning buzzer (in the S mode)To help ensure safety and driving perfor...

19 .

1262-1. Driving proceduresManual Transmission (if equipped)Snow modeThe snow mode is used for accel-erating and driving on slipperyroad surfaces, such as on snow. Push the switch once more toreturn to normal mode. nShifting the shift leverFully depress the...

20 .

1272-1. Driving procedures2When drivingnMaximum downshifting speedAdhere to the downshifting speeds in the following table in order to prevent over-revving the engine. mph (km/h)Shift position Maximum speed1 33 (54)2 56 (90)3 83 (134)4 108 (172)

21 .

1282-1. Driving proceduresTurn signal levernTurn signals can be operated whenThe "ENGINE START STOP" switch is in IGNITION ON mode.nIf the indicators flash faster than usualCheck that a light bulb in the front or re ar turn signal lights has not burned out...

22 .

1292-1. Driving procedures2When drivingParking brakeNOTICEnBefore drivingFully release the parking brake.Driving the vehicle with the parking brake set will lead to brake components over-heating, which may affect braking performance and increase brake wea...

23 .

1302-1. Driving procedures