MINIの取扱説明書・マニュアル [全152ページ 1.43MB]
ownersmanual2004.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2004.pdf - 1.43MB
- キャッシュ
33655view
152page / 1.43MB
112LAMPS AND BULBS 1 Low beams H7 bulb, 55 Watts 2 High beams H7 bulb, 55 Watts The H7 bulb is pressurized. Therefore, wear safety glasses and protective gloves. If the lamp is damaged there is a risk of injury. <Replacing bulbs The headlamps are integrated into the MINI engine compartment.1. Pull on the tab of the cover of the defec-tive lamp and open it2. Press the retaining wire lightly at the eyelet and at the same time guide it out-wards3. Fold the retaining wire down4. Remove the lamp holder and replace the lamp5. Reinsert the lamp holder in the correct position6. Fold the retaining wire back up and catch in place. Ensure that it is placed in the middle of the wire connector.Xenon lamps * The service life of these bulbs is very long and the probability of a failure is very low, provided that they are not switched on and off an unusual number of times. If one of these bulbs should nevertheless fail, it is possible to continue driving with great cau-tion using the fog lamps, provided traffic laws in your area do not prohibit this.Because of the extremely high volt-ages involved, any work on the xenon lighting system should be carried out by technically qualified personnel only. Other-wise, there is a risk of fatal injury. <Turn signal indicators, front 21 Watt bulb 1. Open the bonnet2. Reach into the opening for the turn sig-nal indicators from above3. Apply gentle pressure to the bulb holder while turning it to the left4. Remove and replace the bulb.Parking lamps and standing lamps 5 Watt bulb The parking lamps and standing lamps are integrated in the lamp housing of the turn signal indicator.1. Turn the bulb holder to the left and pull out2. Remove and replace the bulb.
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
33832 view
12142 view
43527 view
3626 view
28978 view
もっと見る