MINIの取扱説明書・マニュアル [全148ページ 2.36MB]
ownersmanual2007hardtop.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2007hardtop.pdf - 2.36MB
- キャッシュ
6180view
148page / 2.36MB
Practical interior accessories70The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.You can operate the system with the engine running or with the ignition switched on.If the system fails to function even after repeated programming, check whether the original hand-held transmitter uses an alter-nating-code system. To do so, either read the instructions for the original hand-held transmit-ter or hold down the programmed memory button1 of the integrated universal remote con-trol. If the LED2 on the integrated universal remote control flashes rapidly for a short while and then remains lit for about two seconds, the original hand-held transmitter uses an alternat-ing-code system. If it uses an alternating-code system, program the memory buttons 1 as described under Alternating-code hand-held transmitters.<Alternating-code hand-held transmittersTo program the integrated universal remote control, consult the operating instructions for the device to be set. You will find information there on the possibilities for synchronization.When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions:Programming will be easier with the aid of a second person.<1.Park your vehicle within the range of the remote-controlled device.2.Program the integrated universal remote control as described above in the section Fixed-code hand-held transmitters.3.Locate the button on the receiver of the device to be set, e.g. on the drive unit.4.Press the button on the receiver of the device to be set. After step 4, you have approx. 30 seconds for the next step 5.5.Press the programmed memory button 1 of the integrated universal remote control three times.The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.Clearing stored programsPress both outer memory buttons 1 for approx. 20 seconds until the LED 2 flashes: all stored programs are cleared.It is not possible to clear individual programs.Glove compartmentOpeningPress the button to open the cover. The light in the glove compartment comes on.ClosingFold cover up.To prevent injury in the event of an acci-dent, close the glove compartment after use while the vehicle is being driven. <Ventilation*Depending on your vehicle's equipment, it may be possible to ventilate the glove compartment.
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
33749 view
12128 view
43447 view
3621 view
28925 view
もっと見る