MINIの取扱説明書・マニュアル [全172ページ 2.73MB]
ownersmanual2009hardtopconvertible.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2009hardtopconvertible.pdf - 2.73MB
- キャッシュ
6099view
172page / 2.73MB
REFERENCE AT A GLANCE CONTROLS DRIVING TIPS MOBILITY 83Practical interior accessoriesIntegrated universal remote control*The conceptThe integrated universa l remote control can replace as many as three hand-held transmitters for various remote-controlled devices, such as garage and gate openers and lighting systems. The integrated universa l remote control regis-ters and stores signals from the original hand-held transmitters.The signal of an original hand-held transmitter can be programmed on one of the three mem-ory buttons1 . The system in question can then be operated by means of the programmed memory button1 . The LED2 flashes to confirm transmission of the signal.If you decide to sell your vehicle one day, in the interest of your own security, remember to clear the stored programs before the vehicle leaves your possession, page84 .To prevent possible damage or injury, before programming or using the inte-grated universal remote control, always inspect the immediate area to make certain that no people, animals or objects are within the pivot-ing or travel range of the device being operated. Comply also with the safety instructions supplied with the original hand-held transmitter. <Checking compatibilityIf this symbol appears on the package or in the instructio ns supplied with the original hand-held transmitter, you can assume that the radio remote control device will be compatible with the integrated universal remote control.For additional information, please contact your MINI Dealer or call: 1-800-355-3515.You can also obtain inform ation on the Internet at: www.MINI.com orwww.homelink.comHomeLink is a registered trademark of Johnson Controls, Inc.Programming1Memory buttons2LEDFixed-code hand-held transmitters1. Switch on the ignition, page43 .2. When starting operation for the first time: press both outer memory buttons 1 for approx. 20 seconds until the LED2 flashes rapidly. All stored programs are cleared.3. Hold the original hand-held transmitter at a distance of approx. 2 to 12 in/5 to 30 cm from the memory buttons 1 .The required distance between the hand-held transmitter and the mem-ory buttons 1 depends on the system of the respective original hand-held transmitter used.<4. Simultaneously press the transmit key on the original hand-hel d transmitter and the desired memory button 1 on the integrated universal remote control. The LED 2 flashes slowly at first. As soon as the LED 2 flashes rapidly, release both buttons. If the LED2 does not flash rapidly after approx. 15 sec-onds, alter the distance.5. To program other original hand-held trans-mitters, repeat steps 3 and 4.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
33125 view
11941 view
43055 view
3554 view
28692 view
もっと見る