X3の取扱説明書・マニュアル [全132ページ 3.62MB]
123805.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123805.pdf - 3.62MB
- キャッシュ
26681view
132page / 3.62MB
Practical interior accessories66Practical interior accessoriesIntegrated universal remote control*The concept The integrated universal remote control replaces up to three different hand-held transmitters for various items of radio-con-trolled equipment such as door openers and house alarm systems. The integrated universal remote control recognizes and learns the transmitted signal of each of the original hand-held transmitters. The signal of an original hand-held trans-mitter can be programmed on one of the three memory buttons 1. Following that, each of the devices can be actuated with the appropriately programmed memory button 1. The indicator lamp 2 flashes to confirm transmission of the signal. If the vehicle is sold, the memory of the memory buttons 1 should be cleared, refer to page 67. To prevent possible damage or injury, before programming or using the inte-grated universal remote control, always inspect the immediate area to make certain that no people, animals or objects are within the travel range of the device. Also, comply with the safety precautions of the original hand-held transmitter. < Checking the compatibility If you see this symbol on the pack-aging or in the manual supplied with the original hand-held transmitter, it is safe to assume that it is compatible with the integrated universal remote control.If you have additional questions, please consult your BMW Sports Activity Vehicle Center or call 1-800-355-3515.You can also visit these websites:www.bmwusa.com or www.homelink.com. HomeLink is a registered trademark owned by Johnson Controls, Inc. < Programming 1Memory buttons 2Indicator lamp Fixed-code hand-held transmitter 1.Turn the ignition key to position 22.For initial use: Press both outer buttons 1 for approx. 20 seconds, maintaining pressure until the indicator lamp 2 starts to flash. The three memory buttons 1 are cleared3.Hold the original hand-held transmitter at a distance of approx. 2 in/5 cm to 8 in/20 cm to the memory buttons 1The required distance between the hand-held transmitter and memory keys 1 depends on the relevant system of the original hand-held trans-mitter used.<4.Simultaneously press the transmit but-ton on the original hand-held transmit-ter and the desired memory key 1 of the integrated universal remote control. Ini-tially, the indicator lamp 2 flashes slowly. Release both buttons as soon as the indicator 2 lamp flashes rapidly. If the indicator lamp 2 does not flash rap-idly after approx. 15 seconds, change the distance 5.To program other original hand-held transmitters, repeat steps 3 and 4.
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
54946 view
21243 view
21397 view
23409 view
22606 view
もっと見る