X3の取扱説明書・マニュアル [全132ページ 3.62MB]
123805.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123805.pdf - 3.62MB
- キャッシュ
26349view
132page / 3.62MB
ReferenceAt a glanceControlsDriving tipsMobility 95Do not fill beyond the upper mark on the dipstick. Excess oil can damage the engine. Adding engine oilWhile you should wait until the level has dropped to just above the lower mark before adding oil, you should never allow the oil level to fall below this mark. BMW engines are designed to oper-ate without additives, and their use could even lead to damage in some cases. This also applies to the manual transmis-sion, automatic transmission, the differen-tial and the power steering system. < Recommendation: have the oil change conducted by your BMW Sports Activity Vehicle Center. Continuous exposure to used oil has caused cancer in laboratory testing. For this reason, any skin areas that come into contact with oil should be thoroughly washed with soap and water. Always store oils, grease and similar mate-rials so that they are inaccessible to chil-dren. Comply with warning labels and information on containers. < Always observe all applicable rules and regulations for environmental protection when disposing of used oil. < Approved engine oils The quality of the engine oil selected has critical significance for the operation and service life of an engine. Based on exten-sive testing, BMW has approved only cer-tain engine oils. Use only approved BMW High Perfor-mance Synthetic Oil.If you are unable to obtain BMW High Per-formance Synthetic Oil, you can add small amounts of another synthetic oil between oil changes. Use only oils with the API SH specification or higher.Ask your BMW Sports Activity Vehicle Center for details concerning the spe-cific BMW High Performance Synthetic Oil or synthetic oils which have been approved.<You can also call BMW of North America at 1-800-831-1117 or visit this website:www.bmwusa.com to obtain this informa-tion.Viscosity ratingsViscosity is the oil flow rating as defined in SAE classes.The selection of the correct SAE class depends on the climate conditions in the area where you typically drive your BMW.Approved oils are in SAE classes 5W-40 and 5W-30. <>These oils may be used for driving in all ambient temperatures.Coolant Indicator lampThe indicator lamp lights up:Coolant level is too low; top up at the earliest opportunity.Do not add coolant to the cooling sys-tem when the engine is hot. Escaping coolant can cause burns. Antifreeze and anticorrosion agents are hazardous to health. You should always store them in their original containers and in a location which is inaccessible to chil-dren. Antifreeze and anticorrosion agents are flammable. Therefore, do not pour over hot engine parts, as otherwise they could catch fire and cause burns. Always observe the instructions for use provided on the containers.<
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
53910 view
21061 view
21216 view
23259 view
22378 view
もっと見る