X3の取扱説明書・マニュアル [全133ページ 8.37MB]
123808.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123808.pdf - 8.37MB
- キャッシュ
23008view
133page / 8.37MB
ReferenceAt a glanceControlsDriving tipsMobility 37If the clutch pedal is not depressed, the motor will not start. <3.Start the engine.Automatic transmission1.Step on the brake.2.Move selector lever into position P.3.Start the engine.Special starting conditionsIn the following situations, press the accelerator pedal halfway down while starting:>If the engine fails to start on the first attempt, for instance, if it is very hot or cold.>When starting the engine at very low tem-peratures, below approx. +5 7/-156, at high altitudes over approx. 3,300 ft/1,000 m.Avoid frequent starting in quick succes-sion or repeated start attempts in which the engine does not start. Otherwise, the fuel is not burned or inadequately burned and there is a danger of overheating and damaging the cat-alytic converter.<Switching off engineDo not remove the ignition key when the vehicle is rolling; otherwise, the steering wheel lock would engage during steering.When leaving the vehicle, remove the ignition key and lock the steering. When parking on downward inclines, engage the handbrake; oth-erwise, the vehicle could start to roll. <Manual transmission1.Apply the handbrake.2.Turn the ignition key to position 1 or 0.3.Shift into first gear or reverse.Automatic transmission1.With the vehicle at a stop, move the selector lever into position P.2.Turn the ignition key to position 1 or 0.3.Apply the handbrake.HandbrakeThe handbrake is primarily intended to prevent the vehicle from rolling while parked; it brakes the rear wheels.Indicator lampThe indicator lamp lights up; an acous-tic signal also sounds when you begin to drive. The handbrake is still engaged.Indicator lamp for Canadian models.EngagingThe lever engages automatically.ReleasingPull up slightly on the lever, press the button and lower the lever.If exceptional circumstances should make it necessary to engage the hand-brake while the vehicle is in motion, do not pull it too strongly. In doing so, continuously press the button of the handbrake lever. Otherwise, strong application of th e handbrake can lead to overbraking of the rear axle and to associated 'fishtailing' of the vehicle rear end. <To prevent corrosion and one-sided brak-ing action, occasionally engage the hand-brake lightly when the vehicle is slowly coming to a stop if the traffic conditions are suitable. The brake lamps do not light up when the hand-brake is applied.<
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
53119 view
26085 view
20837 view
20989 view
22105 view
もっと見る