X3の取扱説明書・マニュアル [全133ページ 8.37MB]
123808.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123808.pdf - 8.37MB
- キャッシュ
23780view
133page / 8.37MB
Technology for comfort, convenience and safety50Activating systemPress the button; the LED lights up.The LED flashes when the brakes are applied automatically.Deactivating systemPress the button again; the LED goes out.HDC is deactivated immediately above approx. 35 mph/60 km/h and after approx. 10 seconds when the ignition is switched off.Using HDCWith manual transmission: Use HDC in first gear and in reverse, because in the higher gears the engine's braking action diminishes.With automatic transmission: You can use HDC in every drive position.MalfunctionIf the LED in the button goes out in the HDC mode or fails to light up when the button is pressed: HDC is temporarily not available, because the brake temperature is too high.Malfunction in vehicle stability control systemsThe warning lamp lights up yellow. DBC Dynamic Brake Control is malfunction-ing. Have the system checked as soon as possible.Display of the previously described mal-function on Canadian models.If one of the malfunctions described below occurs, proceed cautiously and defensively. When driving on poor roads, avoid using the full throttle or kick-down positions of the accelerator as well as heavy and panic brak-ing. Otherwise, the drive train may be damaged or accidents can occur. <The red brake warning lamp lights up together with the warning lamps for ABS and DSC/xDrive. In addition, a warning signal sounds. ABS, DSC, HDC and xDrive have failed. It is then possi-ble to exert driving force only via the rear axle. If the brake warning lamp lights up yellow in the described combi-nation, the EBV Electronic brake-force distribu-tion is still available. Have the system checked as soon as possible.Display of the previously described mal-function on Canadian models.The warning lamp lights up continu-ously and a warning signal sounds:DSC or the xDrive all-wheel system has failed. The stabilizing interventions of DSC or the all-wheel drive system xDrive are no longer avail-able. It is then possible to exert driving force only via the rear axle. Have the system checked as soon as possible.Flat Tire Monitor FTM*The conceptThe Flat Tire Monitor keeps track of the infla-tion pressures in the four mounted tires as you drive. The system triggers an alert whenever the inflation pressure in one tire drops signifi-cantly in relation to the pressure in another tire.When a loss of pressure occurs, the rolling radius changes and with it, the rotational speed
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
56006 view
27221 view
21598 view
21706 view
23048 view
もっと見る