X3の取扱説明書・マニュアル [全133ページ 8.37MB]
123808.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123808.pdf - 8.37MB
- キャッシュ
23409view
133page / 8.37MB
ReferenceAt a glanceControlsDriving tipsMobility 65Practical interior accessoriesIntegrated universal remote control*The conceptThe integrated universal remote control replaces up to three different hand-held trans-mitters for various items of radio-controlled equipment such as door openers and house alarm systems. The integrated universal remote control recognizes and learns the transmitted signal of each of the original hand-held trans-mitters.The signal of an original hand-held transmitter can be programmed on one of the three mem-ory buttons1. Once this is done, each of the devices can be actuated with the appropriately programmed memory button 1. The LED2 indi-cates transmission of the signal.Should you sell your vehicle one day, be sure to delete the stored programs beforehand for your security, refer to page 66.To prevent possible damage or injury, before programming or using the inte-grated universal remote control, always inspect the immediate area to make certain that no peo-ple, animals or objects are within the travel range of the device. Also, comply with the safety precautions of the original hand-held transmitter.<Checking compatibilityIf you see this symbol on the packaging or in the manual supplied with the origi-nal hand-held transmitter, then it is safe to assume that the radio-controlled device is compatible with the integrated universal remote control.If you have additional questions, please ask at your BMW Sports Activity Vehicle Center or call: 1-800-355-3515.You can find also information on the Internet at:www.bmwusa.com or www.homelink.com. HomeLink is a registered trademark of Johnson Controls, Inc. <Programming1Memory buttons2LEDFixed-code hand-held transmitters1.Turn the ignition key to position 2.2.For initial use: Press both outer buttons 1 for approx. 20 seconds, maintaining pressure until the LED2 starts to flash. All stored programs are deleted.3.Hold the original hand-held transmitter at a distance of approx. 2in/5cm to 8in/20cm from the memory buttons 1.The required distance between the hand-held transmitter and memory buttons1 depends on the relevant system of the original hand-held transmitter used. <4.Simultaneously press the transmit button on the original hand-held transmitter and the desired memory button 1 of the inte-grated universal remote control. Initially, the LED2 flashes slowly. Release both buttons as soon as the LED 2 flashes rapidly. If the LED2 does not flash rapidly after approx. 15 seconds, then change the distance.5.To program other original hand-held trans-mitters, repeat steps 3 and 4.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54946 view
26681 view
21243 view
21397 view
22606 view
もっと見る