X3の取扱説明書・マニュアル [全133ページ 8.37MB]
123808.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123808.pdf - 8.37MB
- キャッシュ
23409view
133page / 8.37MB
Practical interi or accessories66The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.You can use the system when the engine is run-ning or when the ignition is switched on.If the system cannot be operated after repeated programming, check whether the original hand-held transmitter uses an alter-nating-code system. To do so, either read the instructions of the original hand-held transmit-ter or press and hold down the programmed memory button 1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time then lights up for approx. 2 seconds, this indicates that the original hand-held trans-mitter uses an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described in the sec-tion below on alternating-code transmitters. <Alternating-code transmittersConsult the operating instructions of the unit you wish to set when programming the univer-sal remote control. You will find information there on the possibilities for synchronization.When programming hand-held transmitters that employ an alternating code, please follow these additional instructions:Programming will be easier with the aid of a second person.<1.Park your vehicle within the range of the remote-controlled equipment.2.Program the integrated universal remote control as described above in the section on Fixed-code hand-held transmitters.3.Locate the button on the receiver of the equipment to be set, e.g. on its drive unit.4.Press the button on the receiver of the device you want to set up. After step 4, you have approx. 30 seconds for step 5.5.Press the programmed memory button 1 of the integrated universal remote control three times.The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.If you have questions, please contact your BMW Sports Activity Vehicle Center. <Deleting stored programsPress both outer buttons 1 for approx. 20 sec-onds, maintaining pressure until the LED 2 starts to flash: all stored programs are deleted.It is not possible to delete individual programs.Cup holdersDo not place glass containers in the cup holders; otherwise, there is a danger of injury in the event of an accident. <FrontDepending on your optional equipment, the center console contains either one or two cup holders.Passenger side*The cup holder for the front passenger is located beneath the air vent.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54946 view
26681 view
21243 view
21397 view
22606 view
もっと見る