X3の取扱説明書・マニュアル [全133ページ 8.37MB]
123808.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123808.pdf - 8.37MB
- キャッシュ
23409view
133page / 8.37MB
ReferenceAt a glanceControlsDriving tipsMobility 95works according to BMW repair procedures with correspondingly trained personnel.Approved engine oilsThe quality of the engine oil selected has critical significance for the operation and service life of an engine. BMW continuously approves spe-cific oils after confirming their suitability for use in its vehicles with extensive testing.Only use approved BMW High Performance Synthetic Oil.If you are unable to obtain BMW High Perfor-mance Synthetic Oil, you can add small amounts of another synthetic oil in between oil changes. Only use oils with the API SH specifi-cation or higher.Ask your BMW Sports Activity Vehicle Center for more details concerning BMW High Performance Synthetic Oil or other approved synthetic oils. <You can also call BMW of North America at 1-800-831-1117 or visit website www.bmwusa.com to obtain this information.BMW engines are designed to operate without additives, and their use could even lead to damage in some cases. <Viscosity classesViscosity is the oil flow rating as defined in SAE classes.The selection of the correct SAE class depends on the climate conditions in the area where you typically drive your BMW.Approved oils belong to SAE classes 5W-40 and 5W-30. <These oils can be used for driving in all ambient temperatures.CoolantWarning lampThe warning lamp lights up: coolant level is too low; top off at the next opportunity.Do not open the cooling system when the engine is hot. Escaping coolant can cause burns.<Coolant consists of water and coolant additive. Not all commercially available additives are suit-able for your BMW. Ask your BMW Sports Activity Vehicle Center for suitable additives.Only use suitable additives; otherwise, engine damage may result. The additives present a health hazard. <Always observe all applicable environ-mental laws and regulations when dis-posing of used coolant additives. <Checking coolant level1.The engine must be at ambient tempera-ture.2.Turn the cap of the expansion tank counter-clockwise to allow any accumulated pres-sure to escape, then continue turning to open.3.The coolant level is correct if the upper end of the red float bar is at least at the same height as the top edge of the filler neck, refer to arrow. The bar end may only pro-trude by a maximum of ιin/2 cm, i.e. up to the second mark on the float bar, refer also to drawing beside the filler neck.4.If the coolant is low, slowly add coolant up to the specified level - do not overfill.5.Screw on the cap and tighten snugly.6.Have the reason for the coolant loss cor-rected as soon as possible.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54946 view
26681 view
21243 view
21397 view
22606 view
もっと見る