Z4の取扱説明書・マニュアル [全120ページ 3.82MB]
123826.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123826.pdf - 3.82MB
- キャッシュ
21365view
120page / 3.82MB
ReferenceAt a glanceControlsDriving tipsMobility 97Pull the ends of the rubber bands upward and out of the fasteners.Always observe all legal regulations requiring a warning tria ngle to be carried in the vehicle.<First-aid kit* The first-aid kit is located beneath the passen-ger seat.To openPull the handle and fold the cover downward.To closeFold the cover up and engage the catch.Some of the articles in the first-aid kit have a limited period of use before expira-tion. For this reason, ch eck the expiration dates of each of the items regularly, and replace any with passed dates. Th ese items can be pur-chased in any drugstore or pharmacy.Always observe all legal regulations requiring a first-aid kit to be carried in the vehicle. <Jump-starting When your battery is discharged you can use two jumper cables to start your vehicle with power from the battery in a second vehicle. You can also use the same method to help start another vehicle. Always use jumper cables with fully insulated handles on the terminal clamps.Do not touch compon ents carrying cur-rent on a running engine. Contact with these components can ca use fatal injury. Care-fully observe the following instructions to avoid personal injury and/or damage to one or both vehicles.<Preparations1.Check whether the batte ry of the support vehicle has 12 volts and approximately the same capacity - measur ed in Ah. This infor-mation is provided on the battery2.Stop the engine of the support vehicle3.Switch off all electrical accessories in both vehicles.Make absolutely certai n that there is no contact between the bodywork of the two vehicles: short circuit hazard. <Connecting jumper cablesAlways adhere to th is sequence when connecting jumper cables; failure to observe this procedure can lead to sparks at the battery terminals and pose an injury hazard. <The auxiliary jump-startin g terminal located in your BMW's engine compartment acts as the positive battery terminal . Refer to the engine compartment overview on page 85. The cover is marked with a+.1.Open the cover of th e BMW auxiliary jump-starting terminal. Do so by pulling the tab2.With the + jumper cable, connect the posi-tive terminal of the drained battery and the positive terminal of the support battery.To do this:Connect one terminal cl amp to the positive terminal of the battery or to an auxiliary jump-starting terminal of the support vehi-cle.Connect the second te rminal clamp to the
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21069 view
21361 view
もっと見る