GSの取扱説明書・マニュアル [全39ページ 0.87MB]
sec_03_07.pdf
http://drivers.lexus.com/.../sec_03_07.pdf - 0.87MB
- キャッシュ
3043view
39page / 0.87MB
3843-7. Other interior featuresGS_G_U (OM30B43U)March 8, 2010 10:20 amn Programming a Rolling Code systemIf your device is Rolling Code equipped, follow the steps under the heading "Programming the HomeLink®" before proceeding with the steps listed below.Locate the learn button on the ceiling mounted garage door opener motor. The exact location and color of the button may vary by brand of garage door opener motor.Refer to the operation manual supplied with the garage door opener motor for the location of the learn button.Press the learn button.Press and hold the vehicle's programmed HomeLink® button for 2 seconds and release it. Repeat this step once again. The garage door may open.If the garage door opens, the programming process is complete. If the door does not open, press and release the button a third time. This third press and release will complete the programming process by opening the garage door.The ceiling mounted garage door opener motor should now recognize the HomeLink® transceiver and operate the garage door.Repeat the steps above to program another rolling code system for any of the remaining HomeLink® buttons.n Programming an entry gate (for U.S.A. owners)/Programming all devices in the Canadian marketPlace your transmitter 1 to 3 in. (25 to 75 mm) away from the sur-face of the HomeLink®.Keep the indicator light on the HomeLink® in view while programming.Press and hold the selected HomeLink® button.Repeatedly press and release (cycle) the device's remote control button for two seconds each until step 4 is completed.When the indicator light on the HomeLink® compatible trans-ceiver starts to flash rapidly, release the buttons.STEP 1STEP 2STEP 3STEP 4STEP 1STEP 2STEP 3STEP 4
参考になったと評価
3人が参考になったと評価しています。
その他の取扱説明書
14487 view
1695 view
7204 view
1566 view
12401 view
もっと見る