MINIの取扱説明書・マニュアル [全140ページ 1.68MB]
ownersmanual2002.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2002.pdf - 1.68MB
- キャッシュ
11748view
140page / 1.68MB
101OVERVIEW REPAIRS OPERATION CONTROLS DATA INDEXLAMPS AND BULBS Proceed carefully when handling lamps and bulbs. If you are not familiar with any of the procedures, consult your MINI center.Do not touch the glass portion of a new bulb with your bare hands since even small amounts of impurities burn into the surface and reduce the service life of the bulb. Use a clean cloth, paper napkin, or a similar material, or hold the bulb by its metallic base. <Replacement bulbs are available from your MINI center.Whenever working on the electrical system, switch off the electrical accessory you are working on or disconnect the cable from the negative terminal of the battery. Failure to do this could result in short circuits.To prevent injuries and damage, comply with any instructions provided by the bulb manufacturer. <1 Low beams H7 bulb, 55 Watts 2 High beams H7 bulb, 55 Watts The H7 bulb is pressurized. Therefore, wear safety glasses and protective gloves. Failure to observe these precautions can result in physical injury if the bulb breaks. <1. Pull off the cover panel of the corre-sponding lamp2. Press the securing wire outwards3. Fold the securing wire downwards4. Remove and replace the bulb.When cleaning the headlamps, please observe the following: do not clean by wiping with a dry cloth (scratches). Never use abrasives or strong solvents to clean the covers. Remove dirt and contami-nation (such as insects) by soaking with shampoo and then rinsing with plenty of water. Always use a deicer spray to remove accumulated ice and snow - never use a scraper. < Xenon lamps * The service life of these bulbs is very long and the probability of a failure is very low, provided that they are not switched on and off an unusual number of times. If one of these bulbs should nevertheless fail, it is possible to continue driving with great caution using the fog lamps, provided traffic laws in your area do not prohibit this.Because of the extremely high volt-ages involved, any work on the xenon lighting system should be carried out by technically-qualified personnel only. Other-wise, there is a risk of fatal injury. <
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
32620 view
42504 view
3450 view
28384 view
36515 view
もっと見る