MINIの取扱説明書・マニュアル [全140ページ 1.68MB]
ownersmanual2002.pdf
gizport - 2013-09-04
http://libraryofmotoring.info/.../ownersmanual2002.pdf - 1.68MB
- キャッシュ
11847view
140page / 1.68MB
91OVERVIEW REPAIRS OPERATIONCONTROLS DATA INDEXCOOLANTDo not add coolant to the cooling system when the engine is hot. Escaping coolant can cause burns.To avoid the possibility of damage later on, never use anything other than factory-approved, nitrite and amino-free extended-duty antifreeze with corrosion inhibitor. Every MINI center is aware of these.Antifreeze and anti-corrosion agents are hazardous to health. Always store these agents in tightly-closed original containers kept well away from the reach of children.Extended-duty antifreeze with corrosion inhibitor contains the flammable substance ethylene-glycol. For this reason, do not spill extended-duty antifreeze with corrosion inhibitor on hot engine parts. It could catch fire and cause serious burns. <Comply with the applicable environ-mental laws regulating the disposal of extended-duty antifreeze with corrosion inhibitor. <The illustration shows an example of thecoolant tank on the MINI COOPER.Checking coolant level Correct coolant level for cold engine (approx. 68 7 /20 6 ):Up to the mark "MAX" of the transparent expansion tank.Only open the cap of the expansion tank when the engine has cooled down. The needle on the coolant tempera-ture gauge in the instrument cluster must be no higher than in the first quarter, otherwise there is a danger of scalding. <To add coolant MINI COOPER:1. Slowly open the cap by turning it with the tab to allow accumulated pressure toescape.2. Pull open the cap completely.3. If the coolant is low, slowly add coolant until the correct level is reached - do not overfill.MINI COOPER S:1. Open the cap by turning it slightly coun-terclockwise to allow accumulated pres-sure to escape. 2. Unscrew the cap completely and open.3. If the coolant is low, slowly add coolant until the correct level is reached - do not overfill.The coolant consists of water and extended-duty antifreeze with corrosion inhibitor. The mixing ratio of 50 to 50 must be maintained all the year round due to the required corrosion resistance. No other additives are required.Replace the coolant every 4 years.
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
32756 view
42671 view
3491 view
28501 view
36673 view
もっと見る