MINIの取扱説明書・マニュアル [全160ページ 2.71MB]
ownersmanual2010clubman.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2010clubman.pdf - 2.71MB
- キャッシュ
7376view
160page / 2.71MB
REFERENCE AT A GLANCE CONTROLS DRIVING TIPS MOBILITY 215.Press and hold the button until the display changes.6.Briefly press the button to select, arrow:> Confirmation signal during unlocking> Confirmation signal during locking7.Press and hold the button until the display changes.8.Briefly press the button to select:>The hazard warning flashers light up dur-ing unlocking/locking.>An acoustic signal sounds during unlock-ing/locking.>The hazard warning flashers light up and an acoustic signal* sounds during unlocking/locking.9.Press and hold the button until the display changes. The setting is stored.Switching on interior lampsWhile the car is locked:Press the button. You can also use this function to locate your vehicle in parking garages, etc.Unlocking the splitdoorPress the button.When it is opened, the splitdoor swings upward and outward to the rear. Make sure that adequate clearance is available before opening.To prevent accidentally locking yourself out, do not place the key down in the cargo bay. If the splitdoor was locked before opening, it will be locked again after it is closed.Before and after each trip, check that the split-door has not been inadvertently unlocked. <MalfunctionsThe remote control may malfunction due to local radio waves. If this occurs, unlock and lock the car at the door lock with the integrated key.If the car can no longer be locked with a remote control, the battery in the remote control is dis-charged. Use this remote control during an extended drive; this will recharge the battery, page18.For US owners onlyThe transmitter and receiver units comply with part 15 of the FCC/Federal Communications Commission regulations. Operation is governed by the following:FCC ID:LX8766S LX8766E LX8CASCompliance statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:>This device must not cause harmful interfer-ence, and>this device must accept any interference received, including interference that may cause undesired operation.Any unauthorized modifications or changes to these devices could void the user's authority to operate this equipment. <
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
33125 view
11941 view
43055 view
3554 view
28692 view
もっと見る