MINIの取扱説明書・マニュアル [全160ページ 2.71MB]
ownersmanual2010clubman.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2010clubman.pdf - 2.71MB
- キャッシュ
7078view
160page / 2.71MB
Practical interior accessories76Practical interior accessoriesIntegrated universal remote control*The conceptThe integrated universal remote control can replace as many as three hand-held transmitters for various remote-controlled devices, such as garage and gate openers and lighting systems. The integrated universal remote control regis-ters and stores signals from the original hand-held transmitters.The signal of an original hand-held transmitter can be programmed on one of the three mem-ory buttons1. The system in question can then be operated by means of the programmed memory button1. The LED2 flashes to confirm transmission of the signal.If you decide to sell your vehicle one day, in the interest of your own security, remember to clear the stored programs before the vehicle leaves your possession, page 77.To prevent possible damage or injury, before programming or using the inte-grated universal remote control, always inspect the immediate area to make certain that no people, animals or objects are within the pivot-ing or travel range of the device being operated. Comply also with the safety instructions supplied with the original hand-held transmitter. <Checking compatibilityIf this symbol appears on the package or in the instructions supplied with the original hand-held transmitter, you can assume that the radio remote control device is compatible with the integrated universal remote control.For additional information, please contact your MINI dealer or call: 1-800-355-3515.You can also obtain information on the Internet at: www.MINI.com orwww.homelink.comHomeLink is a registered trademark of Johnson Controls, Inc.Programming1Memory buttons2LEDFixed-code hand-held transmitters1.Switch on the ignition, page 38.2.When starting operation for the first time: Press both outer memory buttons 1 for approx. 20 seconds until the LED 2 flashes rapidly. All stored programs are cleared.3.Hold the original hand-held transmitter at a distance of approx. 2 in to 12/5 to 30 cm in from the memory buttons 1.The required distance between the hand-held transmitter and the mem-ory buttons1 depends on the system of the respective original hand-held transmitter used.<4.Simultaneously press the transmit key on the original hand-held transmitter and the desired memory button 1 on the integrated universal remote control. The LED 2 flashes slowly at first. As soon as the LED 2 flashes rapidly, release both buttons. If the LED 2 does not flash rapidly after approx. 15 sec-onds, alter the distance.5.To program other original hand-held trans-mitters, repeat steps 3 and 4.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
32749 view
11846 view
42656 view
3490 view
28494 view
もっと見る