MINIの取扱説明書・マニュアル [全254ページ 4.62MB]
ownersmanual2012countryman.pdf
gizport - 2013-09-05
http://libraryofmotoring.info/.../ownersmanual2012countryman.pdf - 4.62MB
- キャッシュ
69229view
254page / 4.62MB
Replacing components MOBILITY 213When working on electrical systems, always begin by switching off the con-sumer in question; otherwise, short circuits could result. To avoid possible injury or equip-ment damage when replacing bulbs, observe any instructions provided by the bulb manufac-turer. <Caring for headlamps, refer to page 209 .For any bulb replacement not described below, contact a MINI dealer or a work-shop that has specially trained personnel work-ing in accordance with th e specifications of the MINI manufacturer.<For checking and adjusting headlamp aim, please contact your MINI dealer.<Light-emitting diodes LEDsLight-emitting diodes installed behind translu-cent lenses serve as the light sources for many of the controls and displays in your vehicle. These light-emitting diodes are related to conven-tional laser diodes, and legislation defines them as Class 1 light-emitting diodes.Do not remove the covers or expose the eyes directly to the unfiltered light source for several hours; otherw ise, this could cause irritation of the retina. <Headlamp glass lensIn cool or humid weather, condensation may occur on the interiors of the headlamps. During trips with the headlamps on, the condensation disappears after a short time. The headlamps do not need to be changed.Do not remove the condensation from head-lamps, despite driving with lights on, and if con-densation increases, e.g., because of water droplets, have this checked by your MINI dealer.Xenon lampsThe service life of these bulbs is very long and the probability of failure very low, provided that they are not switched on and off an excessive number of times. If a xenon lamp fails neverthe-less, switch on the fog lamps and continue the journey with great care, provided that local leg-islation does not prohibit this.Work on the xenon lighting system, including lamp replacement, is only to be carried out only by your MINI dealer. Due to high voltage, there is a risk of fatal injury if work on the xenon lamps is carried out improperly. <Halogen low beams and high beamsH13 bulb, 60/55 wattsThe H13 bulb is pressurized. Therefore, wear safety glasses and protective gloves. Otherwise, there is a risk of injury if the bulb is damaged. <Be careful when inst alling the cover; otherwise, leaks could occur and cause damage to the headlamp system.<Accessing the lamp from the engine compartmentThe low-beam/high-beam bulb can be changed from the engine compartment.Removing the cover:1. Press the tab.2. Flip open the cover and take it out of the holder.Follow the same steps in reverse order to reat-tach the cover.
参考になったと評価
17人が参考になったと評価しています。
その他の取扱説明書
32652 view
11800 view
42538 view
3464 view
28418 view
もっと見る