V70の取扱説明書・マニュアル [全434ページ 8.72MB]
XC70_V70_owners_manual_MY13_en-GB_TP_15282.pdf
http://esd.volvocars.com/.../XC70_V70_owners_manual_MY13_en-GB_TP_15282.pdf - 8.72MB
- キャッシュ
71036view
434page / 8.72MB
03 Your driving environmentLighting 0388* Option/accessory, for more information, see Introduction.Position SpecificationDipped beamA/Dipped beamoff in good light conditions. The"Tunnel detection*" functionactivates dipped beam in poorlight conditions.The function for "Main beamwith automatic activation*" canbe used.Main beam flash operates inthis position.Dipped beamMain beam can be activated.Main beam flash operates inthis position.AApplies to certain markets.Volvo recommends that mode is used,as long as the traffic situation or weather con-ditions are not unfavourable for the function for"Main beam with automatic activation*".Main beam flashMove the stalk switch gently towards the steer-ing wheel to the position for main beam flash.Main beam comes on until the stalk switch isreleased.Dipped beamWhen the engine is started, dipped beam isactivated automatically3 if the headlamp con-trol is in position . If necessary, auto-matic dipped beam for this position can bedeactivated by a workshop. Volvo recom-mends that you contact an authorised Volvoworkshop.In position dipped beam is alwaysswitched on when the engine is running orwhen key position II is active.Main beamMain beam can be activated when the head-lamp control is in position 3 or .Activate/deactivate main beam by moving thestalk switch towards the steering wheel to theend position and release.When main beam has been activated the sym-bol illuminates in the combined instru-ment panel.Main beam with automatic activation -AHB*Main beam with automatic activation (ActiveHigh Beam - AHB) is a function which uses acamera sensor at the top edge of the wind-screen to detect the headlamp beams ofoncoming traffic or the rear lights of vehicles infront, and then switches from main beam todipped beam. The lights are switched back tomain beam a second or so after the camerasensor no longer detects any such light.In cars with this function the headlamp controlhas another design, see page 87.This function can be activated when the head-lamp control is in position . For activationto take place, the engine must have been run-ning for at least 20 seconds and the speed ofthe car must be 20 km/h or higher.3Applies to certain markets, for headlamp control without AUTO mode.
参考になったと評価
53人が参考になったと評価しています。
その他の取扱説明書
1310 view
48 view
1866 view
791 view