X3の取扱説明書・マニュアル [全126ページ 4.65MB]
123806.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123806.pdf - 4.65MB
- キャッシュ
20837view
126page / 4.65MB
Replacing components1004.Slowly lower the handle as far as possible, refer to arrow4.5.Take out the compact wheel towards the back.6.Refit the compact wheel holder in reverse order.The defective wheel will not fit into the compact wheel holder in place of the compact wheel.< Preparing wheel change 1.Observe the safety precautions on page 99.2.Secure the vehicle to prevent it from rolling:Place the wheel chock against the rear sur-face of the front tire on the side opposite the side being raised. If the vehicle is parked on a downward slope, place the wheel chock securely in front of the tire. If the wheel must be changed on a surface with a more severe slope, take additional precautions to secure the vehicle from rolling.3.Loosen the lug bolts by a γ turn.Jacking up vehicle 1.Position the vehicle jack at the jacking point closest to the wheel so that the entire sur-face of the jack base perpendicularly con-tacts the ground under the jacking point.The vehicle jack is designed for changing wheels only. Do not attempt to raise another vehicle model with it or to raise any load of any kind. To do so could cause accidents and personal injury. < 2.Guide the jack head into the rectangular recess of the jacking point when cranking up, refer to section of illustration.3.Jack the vehicle up until the wheel you are changing is raised from the ground.Mounting a wheel1.Unscrew the lug bolts and remove the wheel. 2.Remove accumulations of mud or dirt from the mounting surfaces of the wheel and hub. Clean the lug bolts. 3.Position the new wheel or compact wheel. Secure the wheel by turning at least two lug bolts into opposite bo lt holes. When you mount wheels other than Genuine BMW
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
53119 view
26085 view
20989 view
23008 view
22105 view
もっと見る