X3の取扱説明書・マニュアル [全126ページ 4.65MB]
123806.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123806.pdf - 4.65MB
- キャッシュ
21243view
126page / 4.65MB
Technology for comfort, convenience and safety46Technology for comfort, convenience and safetyPDC Park Distance Control*The concept PDC provides extra safety and convenience during parking maneuvers. Signal tones indi-cate the current distance to an object behind or in front of your vehicle. Four ultrasonic sensors in both the bumpers monitor the distance to the nearest object. The front and rear sensors on the corners have a range of approx. 2 ft/60 cm. The two rear mid-dle sensors have a range of approx. 5 ft/1.50 m and the two front middle sensors of approx. 2.6 ft/80 cm.PDC is a parking aid that can indicate objects when they are approached slowly, as is usually the case when parking. Avoid approaching objects too fast, otherwise the system may give warning of physical obsta-cles too late.<If you tow a trailer, the rear sensors cannot take any practical measurements. Therefore, they do not switch on.Automatic modeIn ignition key position 2, the system is auto-matically activated after approx. one second each time you shift into reverse or move the selector-lever into position R. Wait for this short time span before moving. The system switches off when you shift out of reverse.You can have a signal tone programmed into the system to verify that the PDC is active.<Manual modeIn ignition key position 2, press the button; the indicator lamp lights up. Deactivating manual modePress the button again; the indicator lamp goes out. After driving a distance of more than approx. 160 ft/50 m or exceeding a speed of approx. 20 mph/30 km/h, the system switches off and the indicator lamp goes out. You can reactivate the system manually as needed. Signal tonesThe distance to an object behind the vehicle is signaled, in accordance with the position, by an intermittent tone from a speaker in the rear.The distance to an object in front of the vehicle is signaled by an intermittent tone from a loud-speaker beneath the instrument cluster.As the distance between vehicle and object decreases, the intervals between the tones become shorter. The signal tone becomes con-tinuous once the distance to the nearest object falls to below roughly 1 ft/30 cm. The signal tone is canceled after approx. 3 sec-onds when the distance to an object remains constant during this time, if you are moving par-allel to a wall, for instance.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54946 view
26681 view
21397 view
23409 view
22606 view
もっと見る