X3の取扱説明書・マニュアル [全126ページ 4.65MB]
123806.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123806.pdf - 4.65MB
- キャッシュ
20837view
126page / 4.65MB
Giving and receiving assistance106The tow fittings used should be on the same side on both vehicles. Should it prove impossi-ble to avoid mounting the tow bar at an offset angle, please observe the following: >Clearance and maneuvering capability will be strictly limited in corners. >When mounted at an angle, the tow bar will exert lateral forces, tending to push the vehicle sideways. Secure the tow bar to the tow fitting only. Otherwise damage could result on other vehicle parts.<With tow-rope When starting off in the towing vehicle, make sure that the tow-rope is taut.To avoid jerking and the associated stresses on vehicle components when towing, always use nylon ropes or nylon straps. Secure the tow-rope on the tow fitting only. Otherwise damage could result on other vehicle parts.< With tow truckDo not tow the X3 with only the front or rear axle raised, as otherwise the wheels could lock and the transfer case could be dam-aged.< Only have the X3 transported on a load bed.Tow-starting Do not tow-start vehicles with an auto-matic transmission. Jump starting, refer to page 104.< Vehicles with a catalytic converter should only be tow-started when the engine is cold. It is bet-ter to jump start the engine, refer to page 104. 1.Switch on the hazard warning flashers, comply with country-specific regulations. 2.Turn the ignition key to position 2.3.Engage the 3rd gear. 4.Have the vehicle tow-started with the clutch pedal completely depressed and slowly release the clutch. After the engine starts, immediately depress the clutch pedal com-pletely again. 5.Stop at a suitable location, remove the tow bar or rope and switch off the hazard warn-ing flashers.6.Have the vehicle checked. Do not activate the HDC Hill Descent Control during tow-starting, refer to page48.<
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
53119 view
26085 view
20989 view
23008 view
22105 view
もっと見る