X3の取扱説明書・マニュアル [全126ページ 4.65MB]
123806.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123806.pdf - 4.65MB
- キャッシュ
21096view
126page / 4.65MB
Practical interi or accessories68Do not place heavy and hard objects on the cover. If you do so, they could endan-ger occupants during braking maneuvers. Do not allow the cover to snap back into place, as otherwise it could be damaged. <Removal1.Press the side buttons, refer to arrow 1. 2.Pull the cassette towards the rear, refer to arrow2. InstallationPush the cassette forward into the two side holders until it locks in place. Stowing* when rear seat back is folded downHolders for the cassette are fitted to the backs of the rear seat backs, refer to arrows 1.Guide in the cassette from the right side until it locks in place, refer to arrow 2. Here, the cargo area cover must always point in the direction of travel and the loop of the partition net must point upward.You can pull out the partition net and insert it in the holders in the roof area above.Partition net* Hooking partition net into placePull the partition net out of the cassette by the strap. Push together the bar on both sides, refer to arrows 1, and insert in the brackets. Then press the bar all the way upward in the middle, refer to arrow 2, so that it engages in the brack-ets.Letting down partition netGrasp bar on one side on the partition net, press upward and push together, then release from the brackets.Do not allow the partition net to snap back into place, as otherwise there is a danger of injury and the partition net could be dam-aged.<Behind side trim panelPress the button to open.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
54162 view
26389 view
21244 view
23290 view
22420 view
もっと見る