X3の取扱説明書・マニュアル [全139ページ 4.74MB]
123809.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123809.pdf - 4.74MB
- キャッシュ
22105view
139page / 4.74MB
Things to remember when driving82HillsTo prevent overheating and reduced effi-ciency of the brake system, drive long or steep downhill grades in the gear in which the least braking is required. Otherwise, even light but continuous pressure on the brake can lead to high temperatures, brake wear and possibly even brake failure. <The braking action of th e engine can be further intensified by downshifting, all the way down to first gear if need be. This strategy helps you avoid placing excessive loads on the brake sys-tem. Downshifting in manual mode of automatic transmission, refer to page 40. When descend-ing hills slowly, use HDC Hill Descent Control, refer to page51.Never drive with the clutch depressed, with the transmission in neutral, or with the engine switched off; otherwise, you will have neither the braking action of the engine or nor its power assistance to the brakes or steer-ing. Never allow floor mats, carpeting, or other arti-cles to protrude into the area around the brake or accelerator pedals and obstruct their move-ment.<Corrosion on brake rotorsWhen the vehicle is driven only occasionally, during extended periods when the vehicle is not used at all, and in operating conditions where brake applications are less frequent, there is an increased tendency for corrosion to form on rotors, while contaminants accumulate on the brake pads. This occurs because the minimal pressure which must be exerted by the pads during brake applications to clean the rotors is not reached.Should corrosion form on the brake rotors, the brakes will tend to respond with a pulsating effect that even extended application will fail to cure.Brake padsThe warning lamp lights up.The brake pads have reached their min-imum pad thickness. Have brake pads replaced immediately.Cargo loadingTo avoid loading the tires beyond their approved carrying capacity, never over-load the vehicle. Overloading can lead to over-heating of the tire and increases the rate at which damage develops inside the tires. The ultimate result can assume the form of a sudden blow-out.<Determining load limit1.Locate the following statement on your vehicle's placard*:The combined weight of occupants and cargo should never exceed XXX lbs. or YYY kg. Otherwise, the vehicle may be damaged and unstable driving con-ditions may result. <2.Determine the combined weight of the driver and passengers that will be riding in your vehicle.3.Subtract the combined weight of the driver and passengers from XXX lbs. or YYY kg.4.The resulting figure equals the available amount of cargo and luggage load capacity. For example, if the XXX amount equals 990 lbs. and there will be five 150-lb. pas-sengers in your vehicle, the amount of avail-able cargo and luggage load capacity is 240 lbs.:990 lbs. minus 750 lbs. = 240 lbs.
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
53119 view
26085 view
20837 view
20989 view
23008 view
もっと見る