X3の取扱説明書・マニュアル [全139ページ 4.74MB]
123809.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123809.pdf - 4.74MB
- キャッシュ
22406view
139page / 4.74MB
ReferenceAt a glanceControlsDriving tipsMobility 75Cargo area coverPull the cargo area cover out by the handle and hook it into the rear holders.You can carry light objects such as articles of clothing on the cargo area cover.Never place heavy, hard objects on the cover. If you do so, they could endanger passengers during braking or evasive maneu-vers. Do not allow the cover to snap back into place; this can damage it. <Removal1.Press the side buttons, refer to arrow 1.2.Pull the case toward the rear, refer to arrow2.InstallationPush the case forward into the two side holders until it locks into place.Stowing* when rear backrest is folded downHolders for the case are mounted on the backs of the rear seat backs, refer to arrows 1.Guide the case in from the right side until it locks into place, refer to arrow 2. As you do this, the cargo area cover must always point in the direction of travel and the loop of the partition net must point upward.You can pull out the partition net and insert it into the holders in the roof area above.Partition net*Do not allow the partition net to snap back into place; otherwise, there is a danger of injury and the partition net could be damaged. <Hooking partition net into placePull the partition net out of the case by the strap. Press the ends of the bar toward each other, refer to arrows 1, and insert into the brackets. Then press the bar all the way upward in the middle, refer to arrow 2, so that it engages in the brackets.
参考になったと評価
6人が参考になったと評価しています。
その他の取扱説明書
54139 view
26385 view
21080 view
21235 view
23278 view
もっと見る