X3の取扱説明書・マニュアル [全139ページ 4.74MB]
	
	
	
	
	
		
			
				
				
					123809.pdf
					
					
					gizport  - 2013-09-06
					http://153.127.246.254/.../123809.pdf - 4.74MB 
 - キャッシュ
						25954view
					
					139page / 4.74MB
					
					
				 
				
			 
		 
	 
 
	 
 
	
	
	
		
		
	
	
	
	ReferenceAt a glanceControlsDriving tipsMobility 67Practical interior accessoriesIntegrated universal remote control*The conceptThe integrated universal remote control can replace as many as three hand-held transmit-ters for various radio-controlled accessories, such as garages, exterior gates, or lighting sys-tems. The integrated universal remote control recognizes and learns the transmitted signal of each of the original hand-held transmitters.The signal of an original hand-held transmitter can be programmed on one of the three mem-ory buttons1. Then, the programmed memory button1 can operate the device whenever the ignition is switched on. The LED 2 indicates transmission of the signal.Should you sell your vehicle one day, be sure to delete the stored programs beforehand for your security, refer to page 68.To prevent possible damage or injury, before programming or using the inte-grated universal remote control, always inspect the immediate area to make certain that no peo-ple, animals or objects are within the travel range of the device. Also, comply with the safety precautions of the original hand-held transmitter.<Checking compatibilityIf you see this symbol on the packaging or in the manual supplied with the origi-nal hand-held transmitter, then it is safe to assume that the radio-controlled device is compatible with the integrated universal remote control.If you have additional questions, please ask at your BMW Sports Activity Vehicle Center or call: 1-800-355-3515.You can find also information on the Internet at:www.bmwusa.com or www.homelink.com. HomeLink is a registered trademark of Johnson Controls, Inc. <Programming1Memory buttons2LEDFixed-code hand-held transmitters1.Turn the ignition key to position 2.2.For initial use: press the left and right mem-ory button1 for approx. 20 seconds until the LED2 flashes rapidly. All stored pro-grams are deleted.3.Hold the original hand-held transmitter at a distance of approx. 4 in/10 cm to 12 in/30 cm from the memory buttons 1.The required distance between the hand-held transmitter and memory buttons1 depends on the relevant system of the original hand-held transmitter used. <4.Simultaneously press the transmit button on the original hand-held transmitter and the desired memory button  1 of the inte-grated universal remote control. Initially, the LED2 flashes slowly. Release both buttons as soon as the LED 2 flashes rapidly. If the LED2 does not flash rapidly after approx. 15 seconds, then change the distance and repeat the step.5.To program other original hand-held trans-mitters, repeat steps 3 and 4.
 
	
		
			参考になったと評価
   6人が参考になったと評価しています。
6人が参考になったと評価しています。
		 
		
 
	
		
				その他の取扱説明書
				
					
		
								
									 
									61726 view
								 
		
								
									 
									30051 view
								 
		
								
									 
									24175 view
								 
		
								
									 
									24442 view
								 
		
								
									 
									26575 view
								 
		
		
		
				 
				
				
				
		もっと見る