1. 取扱説明書・マニュアル >
2. BMW >
3. 自動車 >
4. X3 の使い方、故障・トラブル対処法 >
5. X3 の取扱説明書・マニュアル

X3の取扱説明書・マニュアル [全139ページ 4.74MB]

Practical interi or accessories68The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.You can use the system when the engine is run-ning or when the ignition is switched on.If the system cannot be operated after repeated programming, check whether the original hand-held transmitter uses an alter-nating-code system. To do so, either read the instructions of the original hand-held transmit-ter or press and hold down the programmed memory button1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time then lights up for approx. 2 seconds, this indicates that the original hand-held trans-mitter uses an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described in the sec-tion below on alternating-code hand-held transmitters.<Alternating-code hand-held transmittersConsult the operating instructions of the unit you wish to set when programming the univer-sal remote control. You will find information there on the possibilities for synchronization.When programming hand-held transmitters that employ an alternating code, please follow these additional instructions:Programming will be easier with the aid of a second person.<1.Park your vehicle within the range of the remote-controlled equipment.2.Program the integrated universal remote control as described above in the section on Fixed-code hand-held transmitters.3.Locate the button on the receiver of the equipment to be set, e.g. on its drive unit.4.Press the button on the receiver of the device you want to set up. After step 4, you have approx. 30 seconds for step 5.5.Press the programmed memory button 1 of the integrated universal remote control three times.The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.If you have questions, please contact your BMW Sports Activity Vehicle Center. <Deleting stored programsPress the left and right memory button 1 for approx. 20 seconds until the LED 2 flashes rap-idly. All stored programs are deleted.It is not possible to delete individual programs.Digital compass*1Adjusting button2DisplayThe display indicates the cardinal or intercardi-nal direction in which you are currently driving.Basic operationYou can call up a number of functions by press-ing the adjusting button with a sharp object such as a ball-point pen or the like. The follow-ing possible adjustments are displayed one after another, depending on how long you press and hold the adjusting button:>Press briefly: switches display on/off>3 to 6 seconds: set compass zone>6 to 9 seconds: calibrate compass>9 to 12 seconds: set for left-hand/right-hand drive>12 to 15 seconds: set language

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.