Z4の取扱説明書・マニュアル [全120ページ 3.82MB]
123826.pdf
gizport - 2013-09-06
http://153.127.246.254/.../123826.pdf - 3.82MB
- キャッシュ
21354view
120page / 3.82MB
Giving and receiving assistance98positive terminal of th e battery or to an aux-iliary jump-starting termin al of the vehicle to be jump-started.Your BMW is equipped with a special nut, refer also to the engi ne compartment over-view on page853.With the- jumper cable, connect the nega-tive terminals of both vehicles. To do this:Attach one cable clamp to the negative bat-tery terminal or to a suitable ground on the engine or body work of the support vehicle.Attach the second cabl e clamp to the nega-tive battery terminal or to a suitable ground on the engine or body work of the vehicle to be jump-started.Starting the engine1.Start the engine of the support vehicle and let it run for several minutes at a slightly ele-vated engine idle speed2.Start the engine of the other vehicle as usual. If the first start attempt is not successful, wait a few minutes be fore another attempt in order to allow the discharged battery to recharge3.Allow the engines to ru n for several minutes4.Then disconnect the jumper cables in reverse sequence5.Depending on the cause of the fault, have the battery checke d and recharged.Never use spray starter fluids to start the engine.<Towing and tow-starting the vehicle Using the towing eyelet The screw-in towing eyelet is stored in the onboard tool kit; be sure that it remains in the vehicle at all times. It can be attached at the front or rear of your BMW.Observe the following instructions in order to avoid damaging the towing eye-let or the vehicle: use only the towing eyelet supplied with the vehicle, and screw it in firmly until it stops. Use the towing eyelet for towing on paved roads only. Avoid subjecting the tow-ing eyelet to lateral load s, e.g. do not lift the vehicle using the towing eyelet. <Access to the threaded socket Press out the cover with a screwdriver inserted in the recess at the top.Being towedMake sure that the ignition key is in posi-tion 1, because the steering lock could otherwise engage and the vehicle could no longer be steered. There is no power assist while the engine is off. Therefore, you will need to exert more force to brake and steer the vehi-cle.<Turn on the hazard warnin g flashers, if required by national regulations. If the electrical system has failed, clearly iden tify the vehicle being towed, e.g. by placing a sign or a warning trian-gle in the rear window.Vehicles with manual transmissionGearshift lever in idling position.
参考になったと評価
5人が参考になったと評価しています。
その他の取扱説明書
38310 view
31118 view
13898 view
21050 view
21345 view
もっと見る