Z4の取扱説明書・マニュアル [全248ページ 7.63MB]
123860.pdf
gizport - 2013-09-07
http://153.127.246.254/.../123860.pdf - 7.63MB
- キャッシュ
31662view
248page / 7.63MB
Controls 99ReferenceAt a glanceDriving tipsCommunicationsNavigationEntertainmentMobilityThe corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.You can operate the device while the ignition is switched on.If the device fails to function even after repeated programming, check whether the original hand-held transmitter uses an alter-nating-code system. To do so, either read the instructions for the original hand-held transmit-ter or hold down the programmed memory button1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly and then remains lit for about two seconds, the original hand-held transmitter uses an alte rnating-code system. If it uses an alternating-code system, program the memory buttons 1 as described under Alternating-code hand-held transmitters. <Alternating-code hand-held transmittersTo program the integrated universal remote control, consult the operating instructions for the device to be set. You will find information there on the possibilities for synchronization.When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions:Programming will be easier with the aid of a second person.<1.Park your vehicle within the range of the remote-controlled device.2.Program the integrated universal remote control as described above in the section Fixed-code hand-held transmitters.3.Locate the button on the receiver of the device to be set, e.g. on the drive unit.4.Press the button on the receiver of the device to be set. Af ter step 4, you have approx. 30 seconds for step 5.5.Press the programmed memory button 1 of the integrated universal remote control three times.The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.If you have any questions, please contact your BMW center.<Deleting all stored programsPress the left and right memory buttons 1 for approx. 20 seconds until the LED 2 flashes rap-idly: all stored programs are deleted.Reassigning individual programs1.Hold the original hand-held transmitter at a distance of approx. 4 to 12 in/10 to 30 cm from the memory buttons 1.The required distance between the hand-held transmitter and the mem-ory buttons1 depends on the system of the respective original hand-held transmit-ter used.<2.Press the desired memory button 1 of the integrated universal remote control.3.If the LED2 flashes slowly after approx. 20 seconds, press the transmit key of the original hand-held transmitter. Release both buttons as soon as the LED 2 flashes rapidly. If the LED 2 does not flash rapidly after approx. 15 seconds, alter the distance and repeat this step.
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る