Z4の取扱説明書・マニュアル [全248ページ 7.63MB]
123860.pdf
gizport - 2013-09-07
http://153.127.246.254/.../123860.pdf - 7.63MB
- キャッシュ
31662view
248page / 7.63MB
Controls 83ReferenceAt a glanceDriving tipsCommunicationsNavigationEntertainmentMobilityGreenThe tire inflation pressure corresponds to the established target value."TPM active" appears on the Control Display.One wheel yellowThere is a flat tire or su bstantial loss of tire pres-sure in the indicated tire. A message appears on the Control Display.All wheels yellowThere is a flat tire or su bstantial loss of tire pres-sure in several tires. A message appears on the Control Display.GrayThe system cannot detect a puncture.Possible reasons for this:>TPM is being reset>Temporary malfunction caused by systems or devices using the same radio frequency>MalfunctionResetting the systemEach time a tire inflation pressure has been corrected or a wheel or tire has been changed, reset the system. <iDrive, for operating principle refer to page 16.1. Press the button The start menu is opened.2."Vehicle Info"3."Vehicle status"4."Reset TPM"5.Start the engine, but do not start driving.6.Start the initializatio n using "Reset TPM".7.Start to drive.The tires are shown in gray and "Resetting TPM..." is displayed.After driving a few minutes, the set inflation pressures in the tires are accepted as the target values to be monitored. The system reset is completed during your drive, and can be inter-rupted at any time. When driving resumes, the reset is continued automatically. On the Control Display, the tires are shown in green and "Sta-tus: TPM active" is displayed again.If a flat tire is detected while the system is resetting and determining the inflation pressures, all tires on the Control Display are displayed in yellow. The message "Tire low!" is shown.<Message for low tire inflation pressureThe warning lamps come on in yellow and red. A message appears on the Control Display. In addition, a signal sounds. There is a flat tire or substan-tial loss of tire pressure.1.Cautiously reduce speed to below 50 mph/80 km/h. Avoid sudden braking and steer-ing maneuvers. Do not exceed a speed of 50 mph/80 km/h.If the car is not equipped with Run-Flat Tires, refer to page 195, the stan-dard equipment by design, do not continue driving. Otherwise a severe accident could result after a tire punc ture if you continue driving.<
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
38351 view
31138 view
13905 view
21365 view
21069 view
もっと見る