シボレートレイルブレイザーの取扱説明書・マニュアル [全432ページ 2.90MB]
103530.pdf
http://153.127.246.254/.../103530.pdf - 2.90MB
- キャッシュ
54935view
432page / 2.90MB
4-54Safety ChainsYou should always attach chains between your vehicleand your trailer. Cross the safety chains under the tongueof the trailer to help prevent the tongue from contactingthe road if it becomes separated from the hitch.Instructions about safety chains may be provided by the hitch manufacturer or by the trailer manufacturer.Follow the manufacturer's recommendation forattaching safety chains and do not attach them to the bumper. Always leave just enough slack so you can turn with your rig. Never allow safety chains to drag on the ground.Trailer BrakesIf your trailer weighs more than 1,500 lbs. (680 kg)loaded, then it needs its own brakes -- and they must be adequate. Be sure to read and follow the instructionsfor the trailer brakes so you'll be able to install, adjustand maintain them properly.Your trailer's brake system can tap into the vehicle'shydraulic brake system only if:The trailer parts can withstand 3,000 psi (20 650 kPa)of pressure.The trailer's brake system will use less than 0.02 cubic inch (0.3 cc) of fluid from your vehicle'smaster cylinder. Otherwise, both braking systemswon't work well. You could even lose your brakes.If everything checks out this far, then make the brakefluid tap at the port on the master cylinder that sendsfluid to the rear brakes. But don't use copper tubing for this. If you do, it will bend and finally break off. Use steel brake tubing.
参考になったと評価
15人が参考になったと評価しています。
その他の取扱説明書
2198 view
450 view
639 view
387 view
856 view
もっと見る