シボレートレイルブレイザーの取扱説明書・マニュアル [全432ページ 2.90MB]
103530.pdf
http://153.127.246.254/.../103530.pdf - 2.90MB
- キャッシュ
54935view
432page / 2.90MB
6-19To get the right reading, the fluid should be at normaloperating temperature, which is 180 F to 200F (82C to 93C).Get the vehicle warmed up by driving about 15 miles(24 km) when outside temperatures are above 50 F(10C). If it's colder than 50F (10C), drive thevehicle in THIRD (3) until the engine temperature gagemoves and then remains steady for 10 minutes.A cold fluid check can be made after the vehicle hasbeen sitting for eight hours or more with the engine off, but this is used only as a reference. Let the enginerun at idle for five minutes if outside temperatures are50F (10C) or more. If it's colder than 50 F (10C),you may have to idle the engine longer. Should the fluidlevel be low during this cold check, you must check thefluid hot before adding fluid. Checking the fluid hot willgive you a more accurate reading of the fluid level.Checking the Fluid LevelPrepare your vehicle as follows:Park your vehicle on a level place. Keep the engine running.With the parking brake applied, place the shift leverin PARK (P).With your foot on the brake pedal, move the shiftlever through each gear range, pausing for aboutthree seconds in each range. Then, position the shift lever in PARK (P).Let the engine run at idle for three minutes or more.
参考になったと評価
15人が参考になったと評価しています。
その他の取扱説明書
2198 view
450 view
639 view
387 view
856 view
もっと見る