OptiPlex XEの取扱説明書・マニュアル [全6ページ 0.24MB]
2
a Click Reboot system to restart your computer. *Click Software Reboot to restart your computer under software control.*Click Hardware Reboot to restart your computer without performing any shut-down procedure. CAUTION: A Hardware Reboot causes data loss. Sa ve your data to prevent data loss.bClick End the Program to end a non-responsive program. NOTE: Selecting this option will end only th e non-responsive program without automatically restarting it.cClick Restart the Program to end and restart the program.4 Click OK .Configuring the Track Interval and Timeout PeriodOn the Program Monitor tab you can specif y the frequency of the checks performed by the Watchdog timer on the monitored program's status. You can also specify the duration during which the watchdog timer will wait for a program to respond.To configure the Track Interval:1Click the Program Monitor tab on the Watchdog Timer's application interface.2 In the Track Interval (seconds) section, click the or buttons to set the track interval.3 Click the button. A dialog box appears. 4 Enter the Track Interval in seconds and click OK .To configure the Timeout period:1Click the Program Monitor tab on the Watchdog Timer's application interface.2 In the Timeout (seconds) section, click the or buttons to set the timeout period.3 Click the button. A dialog box appears. 4 Enter the Timeout period in seconds and click OK . NOTE: If a program tracked by Watchdog Timer is not responding, then a message appears indicating that the program will reboot after the defined timeout period. The reboot action depends on the action t hat you have selected. For more information,see "Defining the Actions" on page 11.54352.fm Page 12 Monday, July 19, 2010 9:27 AM
