1. 取扱説明書・マニュアル >
2. MINI >
3. 自動車 >
4. MINI の使い方、故障・トラブル対処法 >
5. MINI の取扱説明書・マニュアル

MINIの取扱説明書・マニュアル [全168ページ 2.15MB]

59OVERVIEW REPAIRS OPERATION CONTROLS DATA INDEXPARKING LAMPS/LOW BEAMS1 Parking lamps2 Low beams3 Automatic headlamp control*Parking lampsTurn the light switch to position 1. The front, rear and side vehicle lighting is switched on. For the additional option of activating the lights on one side of the vehicle for parking, refer to Switching on the standing lamps, page59.The parking lamps discharge the bat-tery. Avoid using them for longer periods of time; otherwise, you ma y not be able to start the engine.< Low beamsTurn the light switch to position 2. With the low beams on and with the ignition switched off, only the parking lamps will remain on.Automatic headlamp control *In switch position3, the system automatically activates and can-cels the low beams in response to changes in ambient light, for example in tunnels, at dusk, and when there is precipi-tation.When driving into a tunnel with bright overhead lights, there may be a delay before the low beams come on.The low beams may also come on when the sun is sitting low on a blue sky.When you switch on the fog lamps, the low-beam headlamps remain on regardless of the ambient light. When the daytime driving lamps are activated, refer to page60, the low beams come on and remain lit when the sw itch is in position 1 and the ignition is switched on. <Automatic headlamp control cannot serve as a substitute for the driver's judgement in determining when the vehi-cle lights should be switched on. For exam-ple, the sensors are not able to detect fog. To avoid safety risks, you should respond to these kinds of low-visibility situations by switching the headlamps on manually. <You can have the sensitivity of your vehicle's automatic headlamp con-trol adjusted.<Pathway lightingIf you activate the headlamp flasher after having switched off the engine and the lights, the low beams will stay lit for a pre-set period of time.You can have this function pro-grammed.<Switching on the standing lamps For parking, you can activate lights on one side of the vehicle. Observe local laws.In ignition key position0:Move the lever to the adequate turn signal indicator position.The standing lamps discharge the battery. Avoid using them for longer periods of time; otherwise, you may not be able to start the engine. <

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.