1. 取扱説明書・マニュアル >
2. MINI >
3. 自動車 >
4. MINI の使い方、故障・トラブル対処法 >
5. MINI の取扱説明書・マニュアル

MINIの取扱説明書・マニュアル [全168ページ 2.15MB]

87OVERVIEW REPAIRS OPERATION CONTROLS DATA INDEXINTEGRATED UNIVERSAL REMOTE CONTROL *4. Simultaneously press the command but-ton of the original control device and the desired memory button1 on the inte-grated universal remote control. The LED 2 begins to flash slowly. Release both buttons when LED 2 starts flashing rap-idly. If LED 2 does not start to flash rap-idly after approx. 15seconds, change the distance between the two devices5. Repeat steps 3 and 4 to program other original control devices.The corresponding memory button1 is now programmed with the signal of the original control device.You can operate the system with the igni-tion key in position 2 or 3.If the system cannot be operated after repeated attempts at program-ming, check whether the original control device is equipped with an alternating-code system. You can either check the oper-ating instructions of the original control device for this information, or you can press and hold down the programmed memory button1 of the integrated univer-sal remote control. If LED 2 of the inte-grated universal remote control flashes rapidly for a brief period and then remains on for approx. two seconds, the original control device is equipped with an alternat-ing-code system. In this case, the memory buttons1 are programmed as described for an alternating-code control device. <Alternating-code control deviceYou will need to refer to the operating instructions of the system in question in order to program the integrated universal remote control. Read through the operat-ing instructions for information on syn-chronization.Observe the following additional instruc-tions when you program an alternating-code control device:You will find programming easier if you have the assistance of a second person.<1. Park your vehicle within range of the radio-remote-controlled device2. Program the integrated universal remote control as described above in the section on fixed-code programming3. Locate the button on the receiver of the target device, for example on the upper part of the drive4. Press the button on the receiver of the target device. Once you have completed step4, you have approx. 30 seconds to complete step55. Press the programmed memory button1 of the integrated universal remote control three times.The corresponding memory button1 is now programmed with the signal of the original control device.Consult your MINI Dealer if you have any questions.<Deleting memory buttonsPress both outer buttons1 for approx. 20seconds until LED 2 flashes: all memory buttons are deleted.It is not possible to delete individual mem-ory buttons 1.

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.