1. 取扱説明書・マニュアル >
2. MINI >
3. 自動車 >
4. MINI の使い方、故障・トラブル対処法 >
5. MINI の取扱説明書・マニュアル

MINIの取扱説明書・マニュアル [全168ページ 2.15MB]

77OVERVIEW REPAIRS OPERATION CONTROLS DATA INDEXPARK DISTANCE CONTROL (PDC) * The conceptThe PDC assists you when you back into a parking space. A signal tone tells you the current distance to an object behind your vehicle. To do this, four ultrasonic sensors in the rear bumper measure the distance to the nearest object. The sensors on each side have a range of approx. 2ft/60cm, the middle sensors one of approx. 5ft/1.5m.PDC is a parking aid that can identify objects if they are approached slowly, as is generally the case when parking. Avoid driving towards objects rapidly; due to underlying physical principles, the sys-tem may otherwise alert you too late for you to take evasive steps. <Automatic functionWith the ignition key in position2, the sys-tem starts to operate automatically about one second after you select reverse gear or place the selector lever in position R.Wait for this one second before you drive backwards.<The system is deactivated when you shift away from Reverse.You can have a signal tone set as a confirmation that PDC has been acti-vated.<Acoustical signalsThe distance to an object is indicated by a tone sounding at intervals. As the distance between vehicle and object decreases, the intervals between the tones become shorter. A continuous tone indicates the presence of an object less than 12 in/30 cm away.The warning signal is canceled after approx. three seconds if the distance to the object remains constant during this time, for instance if you are moving parallel to a wall.MalfunctionA continuous high-pit ched tone will sound during initial activation. The system is mal-functioning. Have the system checked.Volume controlThe volume of the Pa rk Distance Control signal can be adjusted from level1, soft, to level6, loud.You can have this function set. <System limitationsEven with PDC, final responsibility for estimating the distance between the vehicle and any objects always remains with the driver. Even when sensors are involved, there is a blind spot in which objects cannot be detected. Recognition of some objects can be beyond the limits of physical ultrasonic measurement, for example with towing bars or hitches or with thin or wedge-shaped objects. It is also possible that low objects already detected, such as a curb edge, can disappear in the blind spot of the sensors before a continuous tone is sounded, or that protruding objects higher above the ground, such as ledges, are not detected.Loud sources of sound outside and inside your vehicle can drown the PDC signal tone.<Keep the sensors clean and free of ice or snow in order to ensure that they will continue to operate effectively. Do not apply high pressure spray to the sensors for a prolonged period of time. Always maintain a distance which is greater than 4in/10 cm. <

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.